HIGHLEAD GC0518-1 Katalog Suku Cadang Manual Instruksi - Halaman 12
Jelajahi secara online atau unduh pdf Katalog Suku Cadang Manual Instruksi untuk Mesin Jahit HIGHLEAD GC0518-1. HIGHLEAD GC0518-1 13 halaman. Heavy duty compound feed lockstitch sewing machine
Juga untuk HIGHLEAD GC0518-1: Buku Petunjuk (10 halaman)
Halaman Cetak
23 ADJUSTMENT
OF NEEDLE BAR
STOP POSITION
(Figs 22, 23)
1 ) Adjusting of "UP" position
When the pedal is kicked down by
heel, the machine stops at "UP"
position. If the marks deviate larger
than 3mm adjust as follows:
Disconnect the plug (12 pins) of
cable from the machine head.
Run the machine and stop at "UP"
position.
While holding the balance wheel
insert the "adjusting tool" in the
hole A, then remove the tool.
2 ) Adjusting of "DOWN" position
Set the machine stops at "DOWN"
position. When the pedal is kicked down by heel the machine stops as "DOWN" position. If the
marks deviate larger than 3mm adjust as follows:
Disconnect the plug (12 pins) of cable from the machine head.
Run the machine and stop at "DOWN'' position.
While holding the balance wheel insert the "adjusting tool" in the hole B, then remove the tool.
3 ) Confirm the stop operation then the plug (12 pins) coming from the machine head into the
receptacle.
B
Pully
Fig 23
Timing
mark arm
1st mark
3rd mark
Fig 22
Adjusting tool
Before
After
3rd mark
Rotating
direction
1st mark
"UP" position
"DOWN" position