HIGHLEAD GC0518-1 사용 설명서 부품 카탈로그 - 페이지 12

{카테고리_이름} HIGHLEAD GC0518-1에 대한 사용 설명서 부품 카탈로그을 온라인으로 검색하거나 PDF를 다운로드하세요. HIGHLEAD GC0518-1 13 페이지. Heavy duty compound feed lockstitch sewing machine
HIGHLEAD GC0518-1에 대해서도 마찬가지입니다: 사용 설명서 (10 페이지)

페이지 인쇄

23 ADJUSTMENT

OF NEEDLE BAR

STOP POSITION

(Figs 22, 23)

1 ) Adjusting of "UP" position

When the pedal is kicked down by

heel, the machine stops at "UP"

position. If the marks deviate larger

than 3mm adjust as follows:

Disconnect the plug (12 pins) of

cable from the machine head.

Run the machine and stop at "UP"

position.

While holding the balance wheel

insert the "adjusting tool" in the

hole A, then remove the tool.

2 ) Adjusting of "DOWN" position

Set the machine stops at "DOWN"

position. When the pedal is kicked down by heel the machine stops as "DOWN" position. If the

marks deviate larger than 3mm adjust as follows:

Disconnect the plug (12 pins) of cable from the machine head.

Run the machine and stop at "DOWN'' position.

While holding the balance wheel insert the "adjusting tool" in the hole B, then remove the tool.

3 ) Confirm the stop operation then the plug (12 pins) coming from the machine head into the

receptacle.

Pully

Fig 23

Timing

mark arm

1st mark

3rd mark

Fig 22

Adjusting tool

Before

After

3rd mark

Rotating

direction

1st mark

"UP" position

"DOWN" position