AFINIBOT A1 Panduan Instalasi - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Printer 3D AFINIBOT A1. AFINIBOT A1 19 halaman.

Step 1 Assemble motor_end

 Put six M3*14mm inner hexagon screws and

M3 cushion rings into the Motor_end , lock

with M3 nuts but do not tighten ,as picture.

 Put the motor on the motor_end , locking

with four M3*10mm and M3 cushion rings.

 Another two motor_ends are the same

assembly

The motor wires is on this side

M3*14mm inner

hexagon screws*6

Motor

Motor_end

M3*10mm inner

hexagon screws*4

M3 cushion

rings*6

M3 nuts