adeptus 10018 Manual Petunjuk Perakitan - Halaman 4

Jelajahi secara online atau unduh pdf Manual Petunjuk Perakitan untuk Gerobak Luar Ruangan adeptus 10018. adeptus 10018 7 halaman. 6 drawer roll cart

Halaman Cetak

PREPARE PARTS FOR ASSEMBLY

• PUSH THE DOWELS (PART A) INTO THE EDGES OF

THE FOLLOWING PARTS, AS SHOWN:

(PART 2) RIGHT SIDE

(PART 3) LEFT SIDE

(PART 6) BACK CASTOR SUPPORT

(PART 7) FRONT CASTOR SUPPORT

ATTACHING DRAWER RUNNERS:

• THE DRAWER RUNNERS (PART D) WILL STRETCH

SLIGHTLY AS YOU HAMMER THEM INTO PLACE.

• LINE UP THE PIPS IN DRAWER RUNNERS (PART D) TO

THE PRE-DRILLED HOLES IN THE RIGHT SIDE PANEL

(PART 2).

• EASE THE PIPS INTO THE HOLES BY TAPPING EACH

PIP DOWN HALF WAY. START ON ONE END, THEN

THE MIDDLE, THEN THE OTHER END.

• WHEN ALL 3 PIPS ARE HALF WAY DOWN AND THE

DRAWER RUNNER (PART D) IS STRETCHED, HAMMER

THE RUNNER ALL THE WAY DOWN UNTIL IT IS FLUSH

WITH THE RIGHT SIDE PANEL (PART 2).

• REPEAT THESE STEPS TO ATTACH THE DRAWER

RUNNERS (PART D) TO THE LEFT SIDE (PART 3).

TIP: Using a regular

hammer to attach the

runners provides a

clearer line of sight than

a rubber mallet.

PREPARE CASTER SUPPORTS:

• USE A HAMMER OR RUBBER MALLET TO

INSERT CASTER INSERT (PART Eb) INTO

THE BOTTOM OF THE FRONT CASTER

SUPPORT (PART 7) AND BACK CASTER

SUPPORT (PART 6).

• TAP ABOVE THE BACK OF THE CASTER

(ABOVE THE STEM) TO ASSEMBLE CASTERS

(PART Ea) INTO THE CASTER INSERT

(PART Eb).

A=12

D=12

Dowel

Drawer runner

8,0 x 30mm

NOTICE:

Eb=04

Ea=04

Caster and insert

CONTAINED

Perform the entire assembly on a

flattened box or a towel to protect

the surface and the unit's finish. DO

Carpet creates too much bounce

making assembly difficult and could

clean, hard surface using the

NOT assemble on carpet.

lead to damage of the parts.

3rd

2nd

1st

4-07