adeptus 10018 조립 지침 매뉴얼 - 페이지 4
{카테고리_이름} adeptus 10018에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. adeptus 10018 7 페이지. 6 drawer roll cart
페이지 인쇄1
PREPARE PARTS FOR ASSEMBLY
• PUSH THE DOWELS (PART A) INTO THE EDGES OF
THE FOLLOWING PARTS, AS SHOWN:
(PART 2) RIGHT SIDE
(PART 3) LEFT SIDE
(PART 6) BACK CASTOR SUPPORT
(PART 7) FRONT CASTOR SUPPORT
ATTACHING DRAWER RUNNERS:
• THE DRAWER RUNNERS (PART D) WILL STRETCH
SLIGHTLY AS YOU HAMMER THEM INTO PLACE.
• LINE UP THE PIPS IN DRAWER RUNNERS (PART D) TO
THE PRE-DRILLED HOLES IN THE RIGHT SIDE PANEL
(PART 2).
• EASE THE PIPS INTO THE HOLES BY TAPPING EACH
PIP DOWN HALF WAY. START ON ONE END, THEN
THE MIDDLE, THEN THE OTHER END.
• WHEN ALL 3 PIPS ARE HALF WAY DOWN AND THE
DRAWER RUNNER (PART D) IS STRETCHED, HAMMER
THE RUNNER ALL THE WAY DOWN UNTIL IT IS FLUSH
WITH THE RIGHT SIDE PANEL (PART 2).
• REPEAT THESE STEPS TO ATTACH THE DRAWER
RUNNERS (PART D) TO THE LEFT SIDE (PART 3).
TIP: Using a regular
hammer to attach the
runners provides a
clearer line of sight than
a rubber mallet.
PREPARE CASTER SUPPORTS:
• USE A HAMMER OR RUBBER MALLET TO
INSERT CASTER INSERT (PART Eb) INTO
THE BOTTOM OF THE FRONT CASTER
SUPPORT (PART 7) AND BACK CASTER
SUPPORT (PART 6).
• TAP ABOVE THE BACK OF THE CASTER
(ABOVE THE STEM) TO ASSEMBLE CASTERS
(PART Ea) INTO THE CASTER INSERT
(PART Eb).
A=12
D=12
Dowel
Drawer runner
8,0 x 30mm
NOTICE:
A
A
D
Ea
A
Eb
A
7
Eb=04
Ea=04
Caster and insert
CONTAINED
Perform the entire assembly on a
flattened box or a towel to protect
the surface and the unit's finish. DO
A
Carpet creates too much bounce
making assembly difficult and could
A
D
2
A
D
D
D
Ea
Eb
A
Ea
A
Eb
A
A
clean, hard surface using the
NOT assemble on carpet.
lead to damage of the parts.
3rd
2nd
1st
D
D
D
D
3
D
Ea
Ea
Eb
6
Eb
A
D
D
A
4-07