Highway Safety Group EA401 Panduan Pengguna - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Sistem Keamanan Highway Safety Group EA401. Highway Safety Group EA401 12 halaman. Driver fatigue eye alert system
Juga untuk Highway Safety Group EA401: Panduan Pengguna (12 halaman)
Halaman CetakVI. Installation
To install on the dashboard: Clean the mounting surface in your car.
Remove the round magnet from the box, remove the paper protector
and stick to the top surface of the dashboard. The EA401 has a metal
base. Connect the power cord to car cigarette lighter. The EA401 will
begin to work after being powered on, now you can adjust the
position according to the state of the green light facing you. After the
green light is on, move your face around a small amount, if the green
light stays on, that means the installation is good.
The USB type wire can connect directly to a GPS or GPRS system. The
output signal is a 3.3 volt logic signal that asserts when the alarm trips.
The secondary power cord can wire directly to 12V power.
The angle between the driver and the camera should be less than 20
degrees.
Highway Safety Group Page 7
Version 11.9.23