Highway Safety Group EA401 사용자 설명서 - 페이지 7

{카테고리_이름} Highway Safety Group EA401에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Highway Safety Group EA401 12 페이지. Driver fatigue eye alert system
Highway Safety Group EA401에 대해서도 마찬가지입니다: 사용자 설명서 (12 페이지)

페이지 인쇄

VI. Installation

To install on the dashboard: Clean the mounting surface in your car.

Remove the round magnet from the box, remove the paper protector

and stick to the top surface of the dashboard. The EA401 has a metal

base. Connect the power cord to car cigarette lighter. The EA401 will

begin to work after being powered on, now you can adjust the

position according to the state of the green light facing you. After the

green light is on, move your face around a small amount, if the green

light stays on, that means the installation is good.

The USB type wire can connect directly to a GPS or GPRS system. The

output signal is a 3.3 volt logic signal that asserts when the alarm trips.

The secondary power cord can wire directly to 12V power.

The angle between the driver and the camera should be less than 20

degrees.

Highway Safety Group Page 7

Version 11.9.23