CORA CS1060 Panduan Pengguna - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pengontrol Suhu CORA CS1060. CORA CS1060 18 halaman. Temperature & humidity sensor

CS1060 Temperature & Humidity Sensor – User Guide

Registering the Device

This step requires a third-party mobile application, which can register new devices. Please

follow the application instructions for registration. Cora devices are typically registered by

scanning the QR code printed on the device housing or attached label.

Once the device is registered, it can be activated by pressing the set button.

The device will activate, blinking orange four times and begin issuing join requests. The LED

status indicators is shown in the figure below.

Figure 2 – CS1060 LED Status Indicators

Periodically, the CS1060 will blink red twice when joining the network. Assuming the device is

properly registered on an available network and in range, it should connect. It will blink green

four times indicating it has joined.

Note: If the CS1060 has not joined within a few minutes, the LED will stop blinking, though it will

continue try to join: ten times in the first hour, then longer intervals over the first week until finally

attempting once every 12 hours. This is done to conserve battery power when the network is not

available for long periods of time. You may reset the join schedule by performing a Network

Reset on the device, see User Interface.

Page 4