CORA CS1060 Посібник користувача - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник користувача для Регулятор температури CORA CS1060. CORA CS1060 18 сторінок. Temperature & humidity sensor
Друкувати сторінкуCS1060 Temperature & Humidity Sensor – User Guide
Registering the Device
This step requires a third-party mobile application, which can register new devices. Please
follow the application instructions for registration. Cora devices are typically registered by
scanning the QR code printed on the device housing or attached label.
Attaching to the Network
Once the device is registered, it can be activated by pressing the set button.
The device will activate, blinking orange four times and begin issuing join requests. The LED
status indicators is shown in the figure below.
Figure 2 – CS1060 LED Status Indicators
Periodically, the CS1060 will blink red twice when joining the network. Assuming the device is
properly registered on an available network and in range, it should connect. It will blink green
four times indicating it has joined.
Note: If the CS1060 has not joined within a few minutes, the LED will stop blinking, though it will
continue try to join: ten times in the first hour, then longer intervals over the first week until finally
attempting once every 12 hours. This is done to conserve battery power when the network is not
available for long periods of time. You may reset the join schedule by performing a Network
Reset on the device, see User Interface.
Page 4