Galvanic Isolator Gi-120/A Petunjuk Manual - Halaman 3

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Peralatan Kelautan Galvanic Isolator Gi-120/A. Galvanic Isolator Gi-120/A 7 halaman.

Installation - Fixing the Isolator continued

As a further measure to prevent water ingress, when fixed, apply a little sealant to the heads of the fixing

screws.

If the lid has been disconnected, re-connect the terminals, ensuring that

they are pushed fully home.

Re-fix the isolator lid. The screws should be tightened firmly, taking care

not to overtighten.

Installation - Connecting the Isolator

Switch off the electricity supply at the shore supply, and disconnect

the shore line.

Connect the isolator to the chosen end of the shore line.

Connect the free end of the isolator to the boat or shore connector.

Switch on the electricity supply at the shore supply.

Check that the RCD test button on the boat operates normally

You are now protected.

Note:

Isolators may be supplied with the connectors either way around. If you wish to

change them this is permissible. Simply interchange the connectors, paying

attention to polarity. Please ensure connecting screws and gland nuts are tight.

To open the connectors, please press clip (see photo), and twist connector

body halves in opposite directions.

If in doubt, please seek advice from a qualified person.

IMPORTANT:

To prevent water ingress, before installation, and

periodically, check Gland

Nuts on both cable ends for

tightness (Blue in photo).

Gland Nuts should be as tight

as possible USING HAND

FORCE ONLY.