Galvin Engineering Safe-Cell 50150 Panduan Instalasi Produk - Halaman 2
Jelajahi secara online atau unduh pdf Panduan Instalasi Produk untuk Produk Pipa Galvin Engineering Safe-Cell 50150. Galvin Engineering Safe-Cell 50150 4 halaman. Prison basin set
Halaman Cetak
PRE-INSTALLATION
MOUNTING DETAILS
If the mounting holes do not already exist, mark out and drill the holes in the bench/trough, as shown
in rough-in dimensions.
Note: Supplied flexi hose length is 450mm long. Maximum distance between outlet and push button
adjustment is 420mm.
4
15.0
420 MAX
22
BENCH / TROUGH
INSTALLATION
INSTALLATION COMPLIANCE: Galvin Engineering products must be installed in accordance with these
installation instructions and in accordance with AS/NZS 3500, the PCA and your local regulatory
requirements. Water and/or electrical supply conditions must also comply to the applicable national and/or
state standards. Failing to comply with these provisions shall void the product warranty and may affect the
performance of the product.
IMPORTANT: Whilst our product designs take into account a broad range of installation types and surfaces,
it is important that surfaces which fixtures are mounted to are flat and free from defect. This is especially
important when installing product ranges that have been designed for correctional and health facilities, where
special attention is required to minimise ligature points and areas for concealment of contraband. In addition
to ensuring the products are fitted securely and in accordance with the following instructions, consideration
shall be given to the use of non-pick mastics such as BASF Sonolastic "Ultra" to ensure a high quality and
safe installation.
4
22
15.0
FLOW DIRECTION
Version 2, 30 August 2018, 2 of 4
22
70
1/2"BSP
BASIN OUTLET
22
1/2"BSP
175
ISOLATING/
REGULATING
BALL VALVE
1/2"BSP
PUSH BUTTON ASSEMBLY
WATER HOSE 15F R/CONE
HEX W/ELBOW x 450mm LONG