AGS Merlin FAM 1 Panduan Pemasangan & Pengoperasian - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pemasangan & Pengoperasian untuk Pengontrol AGS Merlin FAM 1. AGS Merlin FAM 1 8 halaman. Gas service manual reset controller

Halaman Cetak

FAM1

Installation

Introduction

It is recommended that the user reads this guide before using the system.

The FAM1 is an isolation panel with gas solenoid valve output. The FAM1 is designed to provide an effective

way of isolating gas supply by means of a key switch on the panel or by the operation of the emergency

shut off button. The FAM1 can be integrated with a BMS, fire alarm and remote shut-off device(s).

Mounting

Take care when making connections to line voltage connectors!

Any damage attempting to remove the circuit board may void any warranty!

All Class 2 wiring is to be installed within flexible tubing to maintain segregation between circuits!

Wiring of different circuits shall be separated by means of routing, clamping or barrier!

The control panel is designed for surface mounting using 4 mounting screws. Removing the cover on the

panel gives access to the circuit board. The PCB should be removed before drilling entry holes into the

case. A flush mount kit is available, comprising of a mounting bracket and decorative surround strip.

Connections Overview

UTILITY 1

Power Output for gas solenoid valve, 110-120VAC, Max 3A.

POWER

Line Voltage Input 110-120VAC Single Phase. 50-60Hz.

AUTO RESET & BMS

See sections: BMS Integration & Auto reset.

EM REMOTE

This terminal is for remote emergency shut-off buttons and

detailed on the circuit board as [EM REMOTE]. This is linked out as a factory setting. Remote emergency shut-off

buttons should be volt free and wired to the FAM1 using a plenum security cable, white, 18/2 (18AWG 2 conductor),

stranded, CMP or similar.

FIRE PANEL

The terminal for fire alarms is detailed on the circuit board as [FIRE PANEL]. This connection is linked out as a factory

setting. Fire alarms should be volt free and wired to the FAM1 using two-core cable.

BMS OUT

Terminal connections are available on the circuit board for Building Management systems etc.

Detailed on the circuit board as [BMS OUT - N/C, COM and N/O] (Normally Closed / Common / Normally Open). These

are dry contacts. This is a relay that changes state in alarm or when the utility is on/off.

Rev: 01

04-23

Installation & Operation Manual