Galvin Engineering Flowmatic TZ-IQWAVEB Panduan Instalasi Produk - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Instalasi Produk untuk Aksesori Galvin Engineering Flowmatic TZ-IQWAVEB. Galvin Engineering Flowmatic TZ-IQWAVEB 6 halaman. Wave on activated concealed sensor with solenoid, battery powered

Galvin Engineering Flowmatic TZ-IQWAVEB Panduan Instalasi Produk
Version 2, 8 April 2020, 5 of 6
1x
app. 2 sec. till
1x
minimum 3
sec. (max. 5 sec.)
Time of water
flow For
continuous
1x
keep touched
run
till
after releasing
line purge
1x
app. 2 sec. till
feature
activate /
deactivate
<< Automatic
1x
app. 25 sec. till
flush on set
interval>>
(time of
waterflow: 3
Wait till
min)
1x  app. 2 sec. till
2x  a app. 0,5 sec
1x  app. 5 sec. till
restart
electronics
Release and wait till
Wait till

TROUBLESHOOTING

PROBLEM
CAUSE
Sensor Not Responding
False Activation
Water is not flowing
from outlet
1x
+
1x - 40x
+
1x
1x
1x - 4x
1x
1x
4x

+
1x
Damaged or scratched lens
Sensor length to short
Lead damaged
No power
Waving hand too fast
Sensor length too long
Reflection from a light source
Water is off
Solenoid isn't activating
Extended function mode is active
Touch max. 5 sec., water flows
after releasing, number of
40x) shows current setting
1x
=0.5 min. .... 40x
min.
releasing defines duration
check / confirmation of setting by
repeating number of
(1x - 40x)
according to setting
extended function mode is active
1x= off,
2x=12h,
3x= 24h,
4x= 48h ignore flashes after 5 sec.
and 10 sec. – keep touched till
1x - 4x after app. 25 sec.,
releasing defines interval
Confirmation, ready for operation
extended function mode is active
pulsing during active function
1x/sec.
1x/sec., keep out of sensor
area
confirmation, ready for operation
RECTIFICATION
Replace the sensor unit
Adjust beam to correct length.
Replace connected item.
Check power is on or replace battery
Slow down the action in front of the
sensor
Adjust sensor length to correct length
Re-align sensor or shield light source
Turn on mains water
Remove and check the solenoid for debris.
Clean and re-install. Replace solenoid if faulty.
Version 1, 25
th
March 2020 Page 5 of 6
(1x-
0.5-20 min
= 20.0
5 min.
(in 0.5 min
steps)
Off
12 h
12h
24 h
48 h