Galvin Specialised 170.81.11.00 Panduan Instalasi Produk - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Instalasi Produk untuk Produk Pipa Galvin Specialised 170.81.11.00. Galvin Specialised 170.81.11.00 4 halaman. Remote electronic drinking bubbler tap - battery

Halaman Cetak

TOOLS REQUIRED

−

Power drill

−

Spanner or adjustable crescent

−

Screw driver

PRE-INSTALLATION -

−

If the mounting holes do not already exist, mark out and drill

the holes in the bench/trough, as shown in rough-in

dimensions.

Note: Supplied flexi hose length is 225mm long.

Maximum distance between the solenoid and outlet is 210mm.

Note: Before installation, all lines must be flushed.

We recommend that a line strainer be installed prior to drinking

taps to eliminate any foreign material.

INSTALLATION

IMPORTANT: Galvin Specialised products must be installed in accordance with these installation instructions

and in accordance with AS/NZS 3500, the PCA and your local regulatory requirements. Water and/or electrical

supply conditions must also comply to the applicable national and/or state standards. Failing to comply with these

provisions shall void the product warranty and may affect the performance of the product.

1. Disassemble piezo button and outlet

−

Remove back nut and cup washer from the

outlet assembly

−

Remove back nut from piezo button

MOUNTING DETAILS

2. Fit mouthguard outlet

−

Fit the mouthguard outlet into the trough.

−

Ensure the sealing rubber washers are placed

underneath the mouthguard outlet body.

−

Secure underneath with the supplied cup washer and

back nut.

−

Take care not to over-tighten

Version 1,15

March 2021, Page 2 of 4

210 MAX