Galvin Specialised Ezy-Drink Lead Safe 316 SS TD15XEM Panduan Instalasi Produk - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Instalasi Produk untuk Produk Pipa Galvin Specialised Ezy-Drink Lead Safe 316 SS TD15XEM. Galvin Specialised Ezy-Drink Lead Safe 316 SS TD15XEM 4 halaman. Remote electronic drinking bubbler tap

Halaman Cetak
TOOLS REQUIRED
Power drill
Spanner or adjustable crescent
Screw driver
PRE-INSTALLATION -
If the mounting holes do not already exist, mark out and drill the holes in
the bench/trough, as shown in rough-in dimensions.
Note: Before installation, all lines must be flushed.
We recommend that a line strainer be installed prior to drinking taps to eliminate
any foreign material.
INSTALLATION
IMPORTANT: Galvin Specialised products must be installed in accordance with these installation instructions
and in accordance with AS/NZS 3500, the PCA and your local regulatory requirements. Water and/or electrical
supply conditions must also comply to the applicable national and/or state standards. Failing to comply with
these provisions shall void the product warranty and may affect the performance of the product.
1. Disassemble
Remove back nut and cup washer from the
outlet assembly.
Remove the back nut from the piezo button.
MOUNTING DETAILS
Version 1, 7 February 2020, Page 2 of 4
2. Fit mouthguard outlet
Fit the mouthguard outlet into the trough.
Ensure the sealing rubber washers are placed
underneath the mouthguard outlet body.
Secure underneath with the supplied cup washer and
back nut.
Take care not to over-tighten.