Galvin Specialised Ezy-Drink Lead Safe 316 SS TD15XEM Panduan Instalasi Produk - Halaman 4
Jelajahi secara online atau unduh pdf Panduan Instalasi Produk untuk Produk Pipa Galvin Specialised Ezy-Drink Lead Safe 316 SS TD15XEM. Galvin Specialised Ezy-Drink Lead Safe 316 SS TD15XEM 4 halaman. Remote electronic drinking bubbler tap
Halaman CetakSET WATER FLOW DURATION
Button
1.
Switch the power to the controller off.
After 5 seconds switch the power on.
Locate the light on the controller.
Press the piezo button 4 times.
The green light on the controller
should flash 5 times.
TROUBLESHOOTING
PROBLEM
Inconsistent flow
Water is not flowing from
tap
Rate of flow inadequate
WARRANTY
The warranty set forth herein is given expressly and is the only warranty given by the Galvin Engineering Pty
Ltd. With respect to the product, Galvin Engineering Pty Ltd makes no other warranties, express or implied.
Galvin Engineering Pty. Ltd. hereby specifically disclaims all other warranties, express or implied, including
but not limited to the implied warranties of merchantability and fitness for a particular purpose.
Galvin Engineering Pty Ltd products are covered under our manufacturer's warranty available for download
from www.galvinengineering.com.au Galvin Engineering Pty Ltd expressly warrants that the product is free
from operational defects in workmanship and materials for the warranty period as shown on the schedule in
the manufacturer's warranty. During the warranty period, Galvin Engineering will replace or repair any
defective products manufactured by Galvin Engineering without charge, so long as the terms of the
Manufacturer's warranty are complied with.
The remedy described in the first paragraph of this warranty shall constitute the sole and exclusive remedy
for breach of warranty, and Galvin Engineering Pty Ltd shall not be responsible for any incidental, special or
consequential damages, including without limitation, lost profits or the cost of repairing or replacing other
property which is damaged if this product does not work properly, other costs resulting from labour charges,
delays, vandalism, negligence, fouling caused by foreign material, damage from adverse water conditions,
chemical, electrical or any other circumstances over which Galvin Engineering has no control. This warranty
shall be invalidated by any abuse, misuse, misapplication, improper installation or improper maintenance or
alteration of the product.
Controller
2.
Once again, push the piezo button 5 times.
The red light on the controller should now be lit.
Leave the red light on for the desired flow
duration time.
Press the button to finish setting the time.
CAUSE
Blocked flow regulator screw
Water is turned off
Blocked flow regulator screw
The flow regulator screw may
not be adjusted correctly
Version 1, 7 February 2020, Page 4 of 4
RECTIFICATION
Remove flow regulator screw and clean
Turn on water
Remove regulator screw and clean
Remove blanking screw and adjust flow
regulating screw as described in step 6
above