CORBERO TT 160 C Panduan Petunjuk Pengoperasian - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Kulkas CORBERO TT 160 C. CORBERO TT 160 C 14 halaman.
Juga untuk CORBERO TT 160 C: Panduan Petunjuk Pengoperasian (14 halaman)

Halaman Cetak

After changing bulb replace the lamp cover, screw the

plate screw and apply voltage to the appliance.

The lack of light does not influence operation of the

refrigerator.

During operation of the appliance some smaller but

annoying trouble can often occur, which does not

require calling a technician out. In the following chart

information is given about them to avoid unnecessary

charges on service.

The appliance does not

Thermostatic control is set too low.

cool sufficiently

Too many foods to be cooled were put in.

Very warm foods were put in.

Door is not shut properly.

There is no inside cool air circulation.

The appliance cools too

The thermostatic control is set too high.

hard

The appliance does not

Plug is not connected to the mains socket

cool at all

properly.

There is no voltage in the mains socket.

Thermostatic control is in 0 position.

The appliance is noisy

The appliance is not supported properly.

Inasmuch as the advice does not lead to result, call the nearest brand-mark service.

Gross capacity (l)

Net capacity (l)

Width (mm)

Height (mm)

Depth (mm)

Energy consumption

Energy class, according to EU standards

Roted power (W)

Weight (kg)

It is recommended to deliver the appliance in

original

packaging,

considering the protective warning on packaging.

After each transportation the appliance must not be

switched on for approx. 2 hours.

Unpack the appliance and check if there are damages

on it. Report possible damages immediately to the

place you bought it. In that case retain packaging.

Fresh food comp.: 159

Fresh food comp.: 148

550

850

600

(kWh/24h)

0,60

(kWh/year)

219

100

vertical

position

We draw your attention that operation of appliance

goes with certain sounds (compressor- and

circulating sound). This is not trouble, but means

normal operation.

We draw it to your attention again that the

appliance operates discontinuously, so the

stopping of compressor does not mean being no-

current. That is why you must not touch the

electrical parts of the appliance before breaking

the circuit.

Set higher position.

Put fewer foods to be cooled.

Put foods max. at room temperature.

Check if the door is shut.

Provide inside cool air circulation.

Set lower position.

Check if the connection is proper.

Check if there is voltage.

Check setting of thermostatic control.

Check if the appliance stands stable (all the four

feet should be on the floor).

Remove every adhesive tape, which ensure the

parts not to move in the appliance.

Wash the inside of the appliance using lukewarm

water and mild detergent. Use soft cloth.

After cleaning wipe out the inside of the appliance.