CORBERO TT 160 C 사용 설명서 - 페이지 9
{카테고리_이름} CORBERO TT 160 C에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CORBERO TT 160 C 14 페이지.
CORBERO TT 160 C에 대해서도 마찬가지입니다: 사용 설명서 (14 페이지)
페이지 인쇄After changing bulb replace the lamp cover, screw the
plate screw and apply voltage to the appliance.
The lack of light does not influence operation of the
refrigerator.
During operation of the appliance some smaller but
annoying trouble can often occur, which does not
require calling a technician out. In the following chart
information is given about them to avoid unnecessary
charges on service.
The appliance does not
Thermostatic control is set too low.
cool sufficiently
Too many foods to be cooled were put in.
Very warm foods were put in.
Door is not shut properly.
There is no inside cool air circulation.
The appliance cools too
The thermostatic control is set too high.
hard
The appliance does not
Plug is not connected to the mains socket
cool at all
properly.
There is no voltage in the mains socket.
Thermostatic control is in 0 position.
The appliance is noisy
The appliance is not supported properly.
Inasmuch as the advice does not lead to result, call the nearest brand-mark service.
Gross capacity (l)
Net capacity (l)
Width (mm)
Height (mm)
Depth (mm)
Energy consumption
Energy class, according to EU standards
Roted power (W)
Weight (kg)
It is recommended to deliver the appliance in
original
packaging,
considering the protective warning on packaging.
After each transportation the appliance must not be
switched on for approx. 2 hours.
Unpack the appliance and check if there are damages
on it. Report possible damages immediately to the
place you bought it. In that case retain packaging.
Fresh food comp.: 159
Fresh food comp.: 148
550
850
600
(kWh/24h)
0,60
(kWh/year)
219
C
100
34
in
vertical
position
We draw your attention that operation of appliance
goes with certain sounds (compressor- and
circulating sound). This is not trouble, but means
normal operation.
We draw it to your attention again that the
appliance operates discontinuously, so the
stopping of compressor does not mean being no-
current. That is why you must not touch the
electrical parts of the appliance before breaking
the circuit.
Set higher position.
Put fewer foods to be cooled.
Put foods max. at room temperature.
Check if the door is shut.
Provide inside cool air circulation.
Set lower position.
Check if the connection is proper.
Check if there is voltage.
Check setting of thermostatic control.
Check if the appliance stands stable (all the four
feet should be on the floor).
Remove every adhesive tape, which ensure the
parts not to move in the appliance.
Wash the inside of the appliance using lukewarm
water and mild detergent. Use soft cloth.
After cleaning wipe out the inside of the appliance.
23