AFL ASCEND Petunjuk Instalasi - Halaman 3

Jelajahi secara online atau unduh pdf Petunjuk Instalasi untuk Perangkat Keras Jaringan AFL ASCEND. AFL ASCEND 4 halaman. Splice cassette
Juga untuk AFL ASCEND: Petunjuk Instalasi (4 halaman)

Halaman Cetak
INCOMING FIBER PREPARATION (eABF
MAIN TRUNK
1.
Measure and mark the eABF 14" from the end of the main cable trunk
2.
Using wire stripping pliers score and remove the 14" eABF outer jacket segment
3.
Cut the aramid yarn back to the cable sheath cut.
FIBER SPLICING
1.
Orient the splice cradle for single or mass splicing (Figures 3 and 4, respectively).
2.
Organize the prepared incoming fiber and pigtails on a suitable work surface.
3.
Measure and mark the pigtails 27" from the connector boot and cut the fibers (Figure 5 and 6).
4.
Slide the splice sleeves onto the pigtails (Figure 7).
Note: single splice sleeves are 28 mm sleeves. Set Splicer heater accordingly.
5.
Prepare the matched incoming and pigtail fibers for splicing: Strip, Clean, and Cleave. Secure the prepared fibers in the splicer.
6.
Splice Fibers. Position splice sleeve over exposed fiber and use heater to shrink the sleeve. Repeat for all matched incoming and pigtail fiber pairs (Figure 8).
7.
Place each splice sleeve into the splice cradle (Figure 9).
8.
Attach the splice holder assembly cover once all the splice sleeves have been inserted (Figure 10).
Figure 3
Figure 7
1.24.20
®
CABLE MOUNTING CLIP
250 µm
Figure 4
Figure 8
(800) 235-3423 • (864) 433-0333 • AFLglobal.com
AIR-BLOWN FIBER)
14"
Figure 5
Figure 9
Figure 6
Figure 10
3