Gama Sonic 9458970 Buku Petunjuk - Halaman 4
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Lampu luar ruangan Gama Sonic 9458970. Gama Sonic 9458970 4 halaman. Solar post lamp
Halaman CetakReplacing the Batteries and Bulbs
www.gamasonic.com or via our Toll free number: +1-800-835-4113
Replacing the GS Solar LED Light Bulb
The GS Solar LED Light Bulb is designed to last up to 10
years, however if it is not working, or if you want to use a
different color temperature bulb, you can replace it with
a new GAMA SONIC Solar LED Bulb.
1. Make sure the operation switch is in the OFF ("O")
position.
2. Detach the upper part of the lamp as shown in (Fig. 1).
3. Remove the existing A-60 GS Solar LED Light Bulb by
turning it counterclockwise while gripping the base
only see (Fig. 2).
4. Install the new GS Solar LED Light Bulb by turning into
the bulb socket clockwise while gripping the base only
see (Fig. 2).
5. Reassemble the unit by reversing the above procedure
Maintenance
Clean the solar module regularly with a damp towel to guarantee optimum
performance of the solar panel. Do not use any type of solvent for cleaning and
be careful not to put too much pressure on the module while cleaning.
Trouble Shooting
If your solar charged light does not come on at dusk despite
observance of all the instructions, please try the following steps:
1.
Make sure that the solar light is not being affected by any other light source.
2. Ensure the solar light is not positioned in the shade during the day.
3. Make sure the switch in the lamp head is in the" ON" position.
4. Check that the batteries are installed correctly.
NOTE:
The performance of the solar light will vary with the time of year. It will
deliver longer duration when it has had a full day in the sun rather than a day in
overcast weather.
WINTERTIME TIPS: For optimal performance, be sure
to remove any snow or debris accumulation from solar
panel(s). A solar panel free of debris will charge the
batteries much more efficiently.
WARNING: Please keep out of reach of children.
page 4
Replacement batteries are available at
Replacing the Batteries
After several years of use, the battery may need replacing.
1. Make sure the ON/OFF switch is in the "OFF" position (0).
2. Unscrew the four screws on the underside of the lamp top
to detach it from the lamp.
3. Unscrew the battery compartment's screws located on the
silver reflector and remove the compartment doors.
4. Unclip the battery connectors and remove the old
batteries. Make sure the new batteries are high quality –
Li-Ion Battery packs (3.2 Volt / 1500 mAh) with matching
connector (Fig. 5).
connector (Fig. 5).
5. Install the new batteries into the battery compartment.
5. Install the new batteries into the battery compartment.
6. Reassemble the unit by reversing the above procedure.
6. Reassemble the unit by reversing the above procedure.
Fig. 5
WARNING:
in the regular trash, municipal waste stream
or by fire as batteries may leak or explode.
Do not open, short circuit, or mutilate
batteries as injury may occur. Preserve our
environment by recycling Li-Ion batteries or
disposing of them in accordance with local,
State and federal regulations. Do not mix old
and new batteries.
Do not dispose of Li-Ion battery