Gama Sonic 9458970 Kullanım Kılavuzu - Sayfa 4

Dış Mekan Işığı Gama Sonic 9458970 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Gama Sonic 9458970 4 sayfaları. Solar post lamp

Sayfayı Yazdır

Replacing the Batteries and Bulbs

www.gamasonic.com or via our Toll free number: +1-800-835-4113

Replacing the GS Solar LED Light Bulb

The GS Solar LED Light Bulb is designed to last up to 10

years, however if it is not working, or if you want to use a

diﬀerent color temperature bulb, you can replace it with

a new GAMA SONIC Solar LED Bulb.

1. Make sure the operation switch is in the OFF ("O")

position.

2. Detach the upper part of the lamp as shown in (Fig. 1).

3. Remove the existing A-60 GS Solar LED Light Bulb by

turning it counterclockwise while gripping the base

only see (Fig. 2).

4. Install the new GS Solar LED Light Bulb by turning into

the bulb socket clockwise while gripping the base only

see (Fig. 2).

5. Reassemble the unit by reversing the above procedure

Maintenance

Clean the solar module regularly with a damp towel to guarantee optimum

performance of the solar panel. Do not use any type of solvent for cleaning and

be careful not to put too much pressure on the module while cleaning.

Trouble Shooting

If your solar charged light does not come on at dusk despite

observance of all the instructions, please try the following steps:

Make sure that the solar light is not being aﬀected by any other light source.

2. Ensure the solar light is not positioned in the shade during the day.

3. Make sure the switch in the lamp head is in the" ON" position.

4. Check that the batteries are installed correctly.

NOTE:

The performance of the solar light will vary with the time of year. It will

deliver longer duration when it has had a full day in the sun rather than a day in

overcast weather.

WINTERTIME TIPS: For optimal performance, be sure

to remove any snow or debris accumulation from solar

panel(s). A solar panel free of debris will charge the

batteries much more efﬁciently.

WARNING: Please keep out of reach of children.

page 4

Replacement batteries are available at

Replacing the Batteries

After several years of use, the battery may need replacing.

1. Make sure the ON/OFF switch is in the "OFF" position (0).

2. Unscrew the four screws on the underside of the lamp top

to detach it from the lamp.

3. Unscrew the battery compartment's screws located on the

silver reﬂector and remove the compartment doors.

4. Unclip the battery connectors and remove the old

batteries. Make sure the new batteries are high quality –

Li-Ion Battery packs (3.2 Volt / 1500 mAh) with matching

connector (Fig. 5).

5. Install the new batteries into the battery compartment.

6. Reassemble the unit by reversing the above procedure.

Fig. 5

WARNING:

in the regular trash, municipal waste stream

or by ﬁre as batteries may leak or explode.

Do not open, short circuit, or mutilate

batteries as injury may occur. Preserve our

environment by recycling Li-Ion batteries or

disposing of them in accordance with local,

State and federal regulations. Do not mix old

and new batteries.

Do not dispose of Li-Ion battery