Gama Sonic GS-105B-FPW Buku Petunjuk - Halaman 3

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Lampu luar ruangan Gama Sonic GS-105B-FPW. Gama Sonic GS-105B-FPW 4 halaman. Solar lighting

Halaman Cetak

Assembly Instructions:

Post/3"Fitter Mount

Note: If you are replacing an existing gas/electric

post light, you must consult a certified technician

to disconnect them before installation.

1. Attach the fixture (D) to the base (H) with the

four supplied screws, as shown on the right.

2. Install the lamp onto your existing 3" post, using

the screws provided

Pier/ Flat base

Note:There are specific types of screws for

specific surfaces. If unsure of the appropriate

type of screw to use on your desired surface,

please consult a professional.

1. Use a drill to make two holes in the desired

surface.

2. Place the screw anchors into the holes, place

the lamp in line with the holes and secure

with the provided screws.

3. Attach the base (H) to the Pier Mount (G)

with the nut (Fig.1).

4. Attach the fixture (D) to the base (H) with

the four supplied screws, as shown (Fig.2).

Wall Mount

1. Use a drill to make two holes in the desired

surface.

2. Place the screw anchors into the holes, place

the lamp in line with the holes and secure

with the provided screws.

3. Attach the base (H) to the Wall bracket (F)

with the nut (Fig.3).

4. Attach the fixture (D) to the base (H) with

the four supplied screws, as shown (Fig.4).

Operation

Instructions

page 3

1. Remove the Top (B) by unscrewing the 2 screw caps.

Screw the GS LED lightbulb into the socket. Turn on switch

to desired setting high or low (for longer duration). The

Solar Lamp will automatically operate at dusk.

After assembling your specific bracket

here are the steps to finish assembling

your unit, this step applies to all three

brackets:

Place the

lens and cone (C)

in the body (D).

Screw the GS

LED lightbulb into

Fig. 1

the socket. Turn on

switch to desired

setting.

Fig. 2

Attach top

(B) to the body

(D) with the two

Fig. 3

supplied screw

caps.

Fig. 4

2. Reattach the Top (B) and

secure with the 2 screw caps.

Operation Switch

Screw the finial

(A) on top