MAINLINE MLS10010 Panduan Petunjuk Instalasi - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Toilet MAINLINE MLS10010. MAINLINE MLS10010 14 halaman. Dual flush round and elogated toilets

Halaman Cetak

ASSEMBLY INSTRUCTIONS

3. Install Wax Ring (CC*), (Figure 2)

• Turn toilet bowl (B) upside down onto a towel or

cushioned surface. With the rounded (tapered)

end of the ring facing the toilet, place the wax ring

(CC*) around the raised outlet ring of the bowl (B),

and press firmly enough so the wax ring (CC*)

adheres to the bowl (B).

4. Position Toilet Bowl (B) on Toilet Flange, (Figure 3)

• Unplug waste opening in toilet flange. Gently place

toilet bowl (B) (right side up) in position with the

floor bolts (AA*) protruding up through the holes in

the base of the toilet bowl (B). Level toilet bowl (B)

as it is lowered onto the toilet flange.

• Once toilet bowl (B) is in position, press down with

a slight twisting motion on the top center of the

bowl (B); eventually applying full body weight to

evenly compress the wax ring (CC*), creating a

water-tight seal. (Do not rock the bowl

back-and-forth as this may break the seal.)

• Make sure the toilet bowl (B) is as level as

possible. It may be necessary to use small wedges

(shims) under the edge of the bowl due to slight

variations in vitreous chinaware or uneven floors.

(Toilet bowl (B) should be firmly seated on the

floor, so it does not wobble or rock.)

5. Secure Bowl to Floor, (Figure 4)

• Place plastic disc (DD*) (Note: "THIS SIDE UP"),

metal washers (EE*) and nuts (FF*) on floor bolts

(AA*). Alternately tighten nuts (FF*) until toilet bowl

(B) is firmly seated on floor.

• DO NOT OVERTIGHTEN NUTS (FF*) BECAUSE

VITREOUS CHINA CAN EASILY CRACK OR

CHIP.

• Pour water into toilet bowl (B) to prevent the

escape of sewer gases.

• Using a hacksaw, cut off excess length of floor

bolts (AA*) so bolt caps (GG) will fit. (Leave no

more than 1/4-in length above nuts (FF*)). Place

bolt caps (GG) over floor bolts (AA*) and press

down for secure fit.

*AA, CC, DD, EE, and FF not included.

Figure 2

Figure 3

Figure 4