MAINLINE MLS10010 Panduan Petunjuk Instalasi - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Toilet MAINLINE MLS10010. MAINLINE MLS10010 14 halaman. Dual flush round and elogated toilets

Halaman Cetak

ASSEMBLY INSTRUCTIONS

Install Tank (A), (Figure 5)

• Place rubber washer (II) onto bolt (JJ). Insert bolt (JJ)

with washers through hole inside the tank (A).

• Place metal washer (HH) followed by hex nut (KK) onto

bolt (JJ) protruding from bottom of tank (A). Tighten

hex nut (KK) to create a proper and secure seal.

• Attach rubber sealing gasket (LL) to center drain hole

under tank (A).

• Gently place tank (A) on toilet bowl (B) with bolts (JJ)

protruding out underneath.

• Place metal washer (HH) followed by hex nut (KK)

onto the protruding bolt (JJ).

• Tighten hex nut (KK) enough so that the tank (A) sits

flat on the toilet bowl (B).

• Make sure the toilet tank (A) is parallel to the wall and

straight on the toilet bowl (B).

• CAUTION: DO NOT OVERTIGHTEN NUTS. SEVERE

DAMAGE MAY OCCUR.

7. Install Push Button (D)

• Unscrew the tightening nut, which is attached to the button

mechanism.

• Insert the push button body through the tank lid hole. Tighten with

the large nut supplied. (Figure 6)

• Adjust thread rods using locknuts so that the rods are positioned

just over and slightly touching the top of the half flush and full flush

mechanism.

• Note that the half flush is the green tab in the rear and the full flush

is the white tab in front. (Figure 7)

• Note: All toilets come preset and do not need to be adjusted.

Figure 5

Figure 6

Figure 7