HIKOKI WH 18DD Manual Petunjuk Penanganan - Halaman 9

Jelajahi secara online atau unduh pdf Manual Petunjuk Penanganan untuk Pengemudi Dampak HIKOKI WH 18DD. HIKOKI WH 18DD 11 halaman.

Halaman Cetak

Safeguard Function

Overburden Protection

Temperature Protection

MAINTENANCE AND INSPECTION

1. Inspecting the driver bit

Using a broken bit or one with a worn out tip is dangerous

because the bit can slip. Replace it.

2. Inspecting the mounting screws

Regularly inspect all mounting screws and ensure that

they are properly tightened. Should any of the screws be

loose, retighten them immediately. Failure to do so could

result in serious hazard.

3. Maintenance of the motor

The motor unit winding is the very "heart" of the power

tool. Exercise due care to ensure the winding does not

become damaged and/or wet with oil or water.

4. Inspection of terminals (tool and battery)

Check to make sure that swarf and dust have not

collected on the terminals.

On occasion check prior, during and after operation.

CAUTION

Remove any swarf or dust which may have collected on

the terminals.

Failure to do so may result in malfunction.

5. Cleaning on the outside

When the power tool is stained, wipe with a soft dry cloth

or a cloth moistened with soapy water. Do not use chloric

solvents, gasoline or paint thinner, for they melt plastics.

6. Storage

Store the power tool in a place in which the temperature

is less than 40°C and out of reach of children.

NOTE

Storing lithium-ion batteries.

Make sure the lithium-ion batteries have been fully

charged before storing them.

Prolonged storage (3 months or more) of batteries with

a low charge may result in performance deterioration,

signi cantly reducing battery usage time or rendering

the batteries incapable of holding a charge.

However, signi cantly reduced battery usage time may

be recovered by repeatedly charging and using the

batteries two to  ve times.

If the battery usage time is extremely short despite

repeated charging and use, consider the batteries dead

and purchase new batteries.

CAUTION

In the operation and maintenance of power tools, the

safety regulations and standards prescribed in each

country must be observed.

LED Light Display

On 0.1 second/oﬀ 0.5 second

On 0.3 second/oﬀ 0.3 second

Table 3

Remove the cause of the overburdening.

Allow the tool and battery to thoroughly cool.

Important notice on the batteries for the HiKOKI

cordless power tools

Please always use one of our designated genuine

batteries. We cannot guarantee the safety and

performance of our cordless power tool when used with

batteries other than these designated by us, or when

the battery is disassembled and modi ed (such as

disassembly and replacement of cells or other internal

parts).

NOTE

Due to HiKOKI's continuing program of research and

development, the speci cations herein are subject to

change without prior notice.

English

Corrective Action