Gree FLEXX36C Panduan Instalasi - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Pompa Panas Gree FLEXX36C. Gree FLEXX36C 19 halaman. A coils

A-Coil

2.5 General Information

Cooling capacity range as shown below:

Model

FLEXX24C

FLEXX36C

FLEXX48C

FLEXX60C

The evaporator of indoor unit is charged with refrigerant in factory for pressure

maintaining. The cut-off valve can be opened only when installation and vacuuming is

done.

The drain pan must be at least 2" away from a standard gas-fired furnace heat

exchanger and at least 4"-6" away from any drum-type or oil-fired furnace heat

exchanger, depending on furnace model. Closer spacing may damage the drain pan

and cause a leak.

Refer to the Product Specification for the proper use of these coils with specific

furnaces, air handlers, condensers and line sets.

4.1.1 Checking Product Received

After receiving the product, please check if there is any damage caused by

transportation. Shipping damage is the responsibility of the carrier. Verify the model

number, specifications and accessories are correct prior to installation. The distributor

or manufacturer will not accept claims from dealers for transportation damage or

installation of incorrectly shipped units.

4.1.2 Before Installation

Carefully read all instructions for the installation prior to installing product. Make

sure each step or procedure is understood and any special considerations are taken

into account before starting installation. Assemble all tools, hardware and supplies

needed to complete the installation. Some items may need to be purchased locally.

Make sure everything needed to install the product is on hand before starting.

Cooling capacity(ton)

2.0

3.0

4.0

5.0