Majestic Appliances MJ-9200W Panduan Pemilik - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Mesin cuci Majestic Appliances MJ-9200W. Majestic Appliances MJ-9200W 20 halaman. Separate/stacking washer
Juga untuk Majestic Appliances MJ-9200W: Panduan Instalasi (6 halaman), Panduan Pemilik (19 halaman)

in
#_
m
g/Kemovmn
"n
ings
ready
to
appiJaflce
{continued)
Electricity
insta||
y@ur
Make sure that the vottage and frequency available correspond with the values stated on the data place located at
the back of the machine and that the e[ectdc system is dimensioned to withstand the maximum current shown on
the data plate If the socket the machine is connected to does not correspond with the plug, replace the plug with
a suitable one and avoid using adapters or shunts since they could cause over heating and burn out.
Grounding
This appliance must be grounded
In the event of malfunction or breakdown,
grounding will reduce the risk of
electric shock by providing a path of least resistance for eiectric current, This appliance is equipped with a cord
having an equipment-grounding
conductor and a grounding plug The plug must be ptugged into an appropriate
outlet that is propedy installed and grounded in accordance with at local codes and ordinances
WARNING- Improper connection of the equipment-grounding
conductor can result in a risk of electric
shock Check with a qualified service representative or personnel if you are in doubt as to whether the appliance
is properly grounded
Do not modify the plug provided with the appliance: if it will net fit the outlet, have a proper outlet installed
by a qualified electrician
Electrical
Specifications:
VoltagelAmperage
- 115V, 12 Amp, 60 Hz
3 Prong plug attached to the appliance
in the factory
Circuit/Protection.
3 wires single phase, 120V, 60 Hz0AC separate 15 amp circuit
or greater,
Recessed,
Closet
and Alcove
instal|aliens
This appliance
may be installed
in a recessed
area, closet
or alcove.
All measurements
are in
inches.
• If the appliance is to be installed in a closet with zero clearance on the side of the appliance, a total of 12 square
inches of free air space movement to the back of the unit must be allowed into the closet
• tf a door is to be installed that potentially encloses the unit while running, the door must allow for a minimum of
20 square inches of free air movement
"There must also be a 1" space from the front of the unit to the closed door
and 1" from the back of the unit to the wall Additional spacing should be considered for easy installation, servicing,
removal and and compliance
with applicable local, state and federal codes
•The floor must be able to support at least 280 Ibs and a surface that is solid and 1eve!
• installations in RV's or Marine pleasure craft suggest that the machine might best be installed midships in the
boat, or over the axles of the RV where movement is at a minimum
r_
o
03
o
N
Adequate blocking should prevent extreme movement when installed in an RV or Marine pleasure craft,
if the
appliance
is to
be instaBed
in a closet,
the
installation
must
be
compaeted
by a quali-
fied
person
or service
representative.
Additiena!
cUearances
for floor,
waft
or door
moldings
may
be
required,
Page 5
@2003Manufacturers SuppIy,
lnc
c
u_
83
Front View (Recessed)
Side View (Recessed)