Majestic Appliances MJ-9200W 소유자 매뉴얼 - 페이지 6

{카테고리_이름} Majestic Appliances MJ-9200W에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Majestic Appliances MJ-9200W 20 페이지. Separate/stacking washer
Majestic Appliances MJ-9200W에 대해서도 마찬가지입니다: 설치 매뉴얼 (6 페이지), 소유자 매뉴얼 (19 페이지)

페이지 인쇄

g/Kemovmn

ings

ready

appiJaflce

{continued)

Electricity

insta||

y@ur

Make sure that the vottage and frequency available correspond with the values stated on the data place located at

the back of the machine and that the e[ectdc system is dimensioned to withstand the maximum current shown on

the data plate If the socket the machine is connected to does not correspond with the plug, replace the plug with

a suitable one and avoid using adapters or shunts since they could cause over heating and burn out.

Grounding

This appliance must be grounded

In the event of malfunction or breakdown,

grounding will reduce the risk of

electric shock by providing a path of least resistance for eiectric current, This appliance is equipped with a cord

having an equipment-grounding

conductor and a grounding plug The plug must be ptugged into an appropriate

outlet that is propedy installed and grounded in accordance with at local codes and ordinances

WARNING- Improper connection of the equipment-grounding

conductor can result in a risk of electric

shock Check with a qualified service representative or personnel if you are in doubt as to whether the appliance

is properly grounded

Do not modify the plug provided with the appliance: if it will net fit the outlet, have a proper outlet installed

by a qualified electrician

Electrical

Specifications:

VoltagelAmperage

- 115V, 12 Amp, 60 Hz

3 Prong plug attached to the appliance

in the factory

Circuit/Protection.

3 wires single phase, 120V, 60 Hz0AC separate 15 amp circuit

or greater,

Recessed,

Closet

and Alcove

instal|aliens

This appliance

may be installed

in a recessed

area, closet

or alcove.

All measurements

are in

inches.

• If the appliance is to be installed in a closet with zero clearance on the side of the appliance, a total of 12 square

inches of free air space movement to the back of the unit must be allowed into the closet

• tf a door is to be installed that potentially encloses the unit while running, the door must allow for a minimum of

20 square inches of free air movement

"There must also be a 1" space from the front of the unit to the closed door

and 1" from the back of the unit to the wall Additional spacing should be considered for easy installation, servicing,

removal and and compliance

with applicable local, state and federal codes

•The floor must be able to support at least 280 Ibs and a surface that is solid and 1eve!

• installations in RV's or Marine pleasure craft suggest that the machine might best be installed midships in the

boat, or over the axles of the RV where movement is at a minimum

Adequate blocking should prevent extreme movement when installed in an RV or Marine pleasure craft,

if the

appliance

is to

be instaBed

in a closet,

the

installation

must

compaeted

by a quali-

fied

person

or service

representative.

Additiena!

cUearances

for floor,

waft

or door

moldings

may

required,

Page 5

@2003Manufacturers SuppIy,

lnc

Front View (Recessed)

Side View (Recessed)