Centurion R5 Panduan Pengaturan Cepat - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Pengaturan Cepat untuk Pembuka Pintu Garasi Centurion R5. Centurion R5 19 halaman. Rotary swing gate operator
Juga untuk Centurion R5: Panduan Pengaturan Cepat (2 halaman), Panduan Pengaturan Cepat (17 halaman)

Halaman Cetak

1. Get into Programming Mode

WARNING

ONNECT ALL

Connect all cables as required to the control card and battery charger (See

Figure 11 & 12). (IM page 48 & 49)

Check that the power source jumper is in the correct position. (PSU or STD

refer to IM page 27, Fig. 24)

Isolator

Box

To dwelling

Figure 9 Cabling Requirements

1. Always check that the circuit breaker in the electrical panel is in the

OFF position, and that all high voltage circuits (more than 42.4V) are

completely isolated from the mains supply before doing any work.

2. Ensure that all low voltage systems (Less than 42.4V) are suitably

protected from damage, by disconnecting all sources of power such

as chargers and batteries before doing any work.

3. All electrical work must be carried out according to the requirements

of all applicable local electrical codes.(It is recommended that a

licensed electrical contractor perform such work.)

IRING

Electrical Set-Up