Britannia BAS6 Petunjuk Servis & Perawatan - Halaman 3

Jelajahi secara online atau unduh pdf Petunjuk Servis & Perawatan untuk Alat Pemadam Api Ringan Britannia BAS6. Britannia BAS6 4 halaman. Stored pressure powder extinguishers

Halaman Cetak

SPSPP

1. Remove extinguisher from hanging bracket and check security of the bracket, rectify if

necessary. Check exterior of extinguisher for corrosion or damage, if found, withdraw from

service.

2. Ensure safety pin is in position and the extinguisher has not been completely or partially

discharged. If the extinguisher has been completely or partially discharged, discontinue

servicing procedure and commence recharge procedure (Ref. RPSPP).

3. Ensure instruction label is legible, rectify as necessary. Check for damage/corrosion to

extinguisher body. If damage/corrosion is found, mark the extinguisher as condemned

and/or remove from service.

4. Checkweigh the extinguisher against the gross weight recorded when first installed. If

underweight by more than 10% of contents, the extinguisher should be removed from

service and recharged. Invert extinguisher to loosen powder.

5. Check safety pin for free movement. Refit pin and fit new seal and service indicator (in

accordance with service colour code).

6. Check pressure gauge is reading 12 bar (@+20ºc) in the green zone. Check that gauge is

operational by using gauge test kit, ensure that after testing, the needle returns to the

original mark. Fit new gauge sticker. If a deviation of more than 10% is recorded, remove

extinguisher from service and recharge.

7. Check discharge hose, nozzle and clips for wear, cuts or abrasion, where fitted. Replace as

necessary.

8. Fill in details of service, including extinguisher weight, on service label using indelible pen.

Clean extinguisher and return to service.

SERVICING PROCEDURES FOR BRITANNIA RANGE

STORED PRESSURE POWDER MODELS

MODEL NO'S: BAS2, BAS4, BAS6, BAS9, BMS9

Page 3 of 4

REV 2: September 2010