Gamo 621213554 Buku Petunjuk - Halaman 2

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Pompa Air Gamo 621213554. Gamo 621213554 3 halaman. Hand pump pcp

Halaman Cetak

1. FEATURES

· Length: 24.1 in (630 mm) Closed ; 43.3 in (1,100 mm) Open

· Weight: 5.29 lb (2.4 kg)

· Max. Pressure: 310 BAR or 4500 psi.

· Folding Base Plate

· This PCP pump could be continuously used for more than 2 hours based on 200 BAR.

· Output nut: 1/8 BSP

2. ACCESSORY LIST

01 special key.

1 pc

02 high pressure stem sealing ring.

2 pcs

03 high pressure piston ring.

2 pcs

04 O ring.

5 pcs

05 outer tube piston ring.

2 pcs

06 check valve spring.

2 pcs

07 sealing gasket of bleed valve.

2 pcs

08 high pressure piston spring.

2 pcs

09 low pressure piston ring.

2 pcs

10 high pressure spool valve.

2 pcs

11 inlet hole one-way seal ball.

2 pcs

12 key.

1 pc

13 key.

1 pc

3. INSTALL

Following the graphic, connect the pressure gauge, the output hose and the 8 mm (0.31 in) quick

connector using the special key.

Moderate strength can be applied but do not over tighten it as this could cause the sealing

CAUTION:

ring between the pressure gauge / hose and base plate to be deformed and jammed. The rubber grip must

be tightened and should not be loose.

A- Rubber Grip

B- Pump Barrel

C- Base Plate

D- Pressure Gauge

E- Moisture Filter

F- Hose

G- Quick Connector

H- Test Plug

I- Bleed Valve

5. OPERATION

· It is important that you become familiar with the correct method of operation as the incorrect operation

could result in damage to the pump and possibly to the user.

· Please connect the pump and bottle, the connector will be supplied when you buy the bottle. Please

connect it according to the corresponding instruction manual.

properly used.

· Please make sure that the bleed valve is tightened.

When pumping the air, please be sure the hose is not knotted. Then pull and push the pump steadily. You will

begin to feel more resistance when the pressure in the bottle equals 100 BAR or above, this is normal.

· Please open the bleed valve screw to release the residual/excess air in the pump, barrel and hose. It is

normal to see a small amount of air and water leak from the bleed valve. You can easily remove the filler

probe/valve after releasing the air from bleed valve.

CAUTION:

Before starting to fill the bottle, please read the instruction manual to ensure the product is

WARNING:

4. TEST

Step 1: Put the test plug into the 8 mm (0.31 in) quick

connectors, open the bleed valve (the bleed valve is in the

back of the base). Continuously pump air about 20 times

(in order to do that, pull the handle all the way up rapidly

and push it all the way down using your own weight).

Step 2: Tighten the bleed valve and pump until the

pressure is up to 100 BAR, then open the bleed valve

quickly to release the air. After that, tighten the bleed valve

again, inflate the pressure up to 200 BAR. Please check

the pressure gauge to see if the needle has fallen. (If the

needle has fallen, there will be an air leak. The best way to

find a leakage point is to put the pump, hose and test plug

under water together).