Century Helicopter Products Hummingbird Elite Series CP Buku Petunjuk - Halaman 6

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Mainan Century Helicopter Products Hummingbird Elite Series CP. Century Helicopter Products Hummingbird Elite Series CP 12 halaman. Elite series helicopter

Halaman Cetak
Century Helicopter Products Hummingbird Elite Series CP Buku Petunjuk
Section 3a
Section 3a
Section 3a
Section 3a
Section 3a
MOUNTING YOUR SERVOS (CP) USE SECTION 4 FOR EXACT MEASUREMENTS
1. Insert the pushrod into the hole on
the servo arm farthest from the output
(10-12mm from center).
2. Place servo tape on the mounting
surface before mounting the servo.
3. Note that the elevator servo is
mounted slightly forward (3mm or so).
This will ensure that the arm can move
freely.
4
7. Turn the radio on with all sticks and trims centered. Verify also that
paddles, swashplate & servo horns are parallel to each other and also
90 degrees to the main shaft when all sticks are centered.
Adjust the lengths of the pushrods by twisting the ball links clockwise to
shorten. Twist counter-clockwise to increase the rod length.
8.) The Hummingbird Elite Collective Pitch helicopter uses the eCCPM
control system. This system will require a computer helicopter radio that
supports 120 degree eCCPM. Refer to Page 7 for detailed instructions
on how to use eCCPM.
Collective
Pitch Servo
8
Elevator
servo
6
Servo Inst
Servo Inst
Servo Install
Servo Inst
Servo Inst
1
5
Top View
Front
all
alla a a a a tion and pushrod
all
tion and pushrod
tion and pushrod
all
tion and pushrod
tion and pushrod
setup for the CP
setup for the CP
setup for the CP
setup for the CP
setup for the CP
2
6
Main shaft
Swashplate
Adjustable
pushrod and
ball link
Servo horn
7
IMPORTANT:
Refer to Page 7 for
detailed instructions on
how to use the eCCPM
control system.
Aileron
servo
3
4. If the servo has a label on the same side
that will mount with servo tape, peel off the
label and clean the surface using rubbing
alcohol. Once the mounting position of the
servo is determined carefully mount the servo
to the mast tower.
5. After mounting the servo. Place the plastic
ball link on the corresponding control ball on
the swashplate. Only use the large end of the
tapered opening on the ball link.
6. There are 3 servos needed on the CP.
When mounted they should appear as
pictured.
Ball Links
Ball Links
Ball Links
Ball Links
Ball Links
The correct side of the ball
link to mount has a larger
opening than the other side
!
and also has a lip in the
plastic around the opening.
Ball link closed end
Ball link open end with lip
90
O
angle