HIKVISION TURBO HD H0T Series Panduan Pengguna - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kamera Keamanan HIKVISION TURBO HD H0T Series. HIKVISION TURBO HD H0T Series 16 halaman. Turbo hd turret & dome camera
Juga untuk HIKVISION TURBO HD H0T Series: Panduan Pengguna (16 halaman), Panduan Pengguna (17 halaman), Panduan Pengguna (14 halaman)
Halaman Cetak
2.2 Installation of Type II Camera
Before you start:
Both wall mounting and ceiling mounting are suitable for
the turret camera. Ceiling mounting will be taken as an
example in this section. You can take steps of ceiling
mounting as the reference, when adopting the wall
mounting.
Steps:
1. Disassemble the turret camera by rotating the camera
to align the notch to the clip plate, as shown in the
Figure 2-10.
Figure 2-10 Disassemble the Camera
2. Pry the mounting base to remove the mounting base
from the camera body.
3. Paste the drill template (supplied) to the place where
you want to install the camera.
4. Drill the screw holes according to the drill template,
and the cable hole (optional) on the ceiling.
Note:
Drill the cable hole in the center of the drill template,
when adopting the ceiling outlet to route the cable.
5. Secure the mounting base to the ceiling with the
supplied screws.
Figure 2-12 Fix the Mounting Base to the Ceiling
Note:
The supplied screw package contains self-tapping
screws, and expansion bolts.
For cement wall/ceiling, expansion bolts are
required to fix the camera. For wooden wall/ceiling,
self-tapping screws are required.
6. Route the cables through the cable hole, or the side
opening.
7. Secure the camera on the mounting base.
Figure 2-11 Drill Template
Expansion Bolts
Fixing Screw
Clip Plate
Notch