KitchenAid KD-20 SERIES Panduan Petunjuk Instalasi - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Mesin pencuci piring KitchenAid KD-20 SERIES. KitchenAid KD-20 SERIES 6 halaman. Built-in dishwasher

Halaman Cetak

CUSTOM

WOOD

PANELS

If custom wood panels are to be used, they should be l/4"

thick.

Length and

width

dimensions

should

be the same as front

panel inserts. Use front panel

inserts as patterns.

If wood

panels are less than

l/4"

thick

they must be shimmed

up to the

required

l/4"

with proper size back up board (corrugated,

masonite,

etc.). If

panels are thicker

than l/4",

the panel edges will have to be trimmed

down

on all four sides. The portion

of panel that is under stainless steel trim (over-

lay portion)

must be l/4"

thick.

This "overlay"

portion

of the lower panel

must be inset a minimum

of l/4"

from

the perimeter.

The inset for the

upper (door)

panel must be l/4"

on both sides, 1" on the bottom

edge and

l/4"

plus desired clearance around the door handle on the top edge.

When wood

panels are used, heavier door springs, #C-240418,

should

ordered (2 required).

Door Panel Size:

23-g/16"

wide x 18-7/8"

high

Lower Panel Size:

23-1 l/16"

wide x 6-5/8"

high

CAUTION:

The finish

applied

to the wooden

front panels should be applied

to both the front

and back sides and all edges, andmust

be waterproof

since

a certain amount

of moist air does discharge from the machine.

CAUTION

For installation

when the dishwasher

is to be left unused

in freezing

temperature:

Turn

off electrical

power and

shut off water supply

at the hand valve. Remove lower

panel.

Disconnect

both

inlet

and outlet

lines at the

DRAIN

valve.

This

permits

water

to drain

from

the

dishwasher

tank, pump and drain line. Disconnect

both

the inlet

and outlet

lines at the FILL

valve. Make pro-

visions

to control

water

drained

from

unit.

Reinstall

lower panel. Turn on electrical

power.

On Custom

and Imperial

models,

close door and latch

handle.

Turn

Cycle

Selection

Dial

until

it clicks

"Rinse

& Hold"

position.

Push "Rinse

& Hold"

button

and allow

machine

to run until

it turns

off.

Turn

off

electricity.

On Patrician

and Superba models, close door and latch

handle.

Push "Rinse

& Hold"

button.

Allow

machine

to run four or five minutes.

Push "Cancel

Cycle"

button

and wait

for machine

to turn off. Turn off electricity.

To complete

installation

later:

Remove lower panel.

Connect

drain

and fill

valves (both

inlet

and outlet).

Reinstall

lower panel.

Turn on water and electrical

supplies.

KITCHENAID

DIVISION

TROV,

OHIO

45374

FORM

1366OA

(2-61)

(Sup&.

F. 136MI

PRINTED

IN U.SA.

4177829

Ivhpl.