KitchenAid KD-20 SERIES Instrukcja instalacji - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Zmywarka KitchenAid KD-20 SERIES. KitchenAid KD-20 SERIES 6 stron. Built-in dishwasher
Drukuj stronęCUSTOM
WOOD
PANELS
If custom wood panels are to be used, they should be l/4"
thick.
Length and
width
dimensions
should
be the same as front
panel inserts. Use front panel
inserts as patterns.
If wood
panels are less than
l/4"
thick
they must be shimmed
up to the
required
l/4"
with proper size back up board (corrugated,
masonite,
etc.). If
panels are thicker
than l/4",
the panel edges will have to be trimmed
down
on all four sides. The portion
of panel that is under stainless steel trim (over-
lay portion)
must be l/4"
thick.
This "overlay"
portion
of the lower panel
must be inset a minimum
of l/4"
from
the perimeter.
The inset for the
upper (door)
panel must be l/4"
on both sides, 1" on the bottom
edge and
l/4"
plus desired clearance around the door handle on the top edge.
When wood
panels are used, heavier door springs, #C-240418,
should
be
ordered (2 required).
Door Panel Size:
23-g/16"
wide x 18-7/8"
high
Lower Panel Size:
23-1 l/16"
wide x 6-5/8"
high
CAUTION:
The finish
applied
to the wooden
front panels should be applied
to both the front
and back sides and all edges, andmust
be waterproof
since
a certain amount
of moist air does discharge from the machine.
CAUTION
For installation
when the dishwasher
is to be left unused
in freezing
temperature:
Turn
off electrical
power and
shut off water supply
at the hand valve. Remove lower
panel.
Disconnect
both
inlet
and outlet
lines at the
DRAIN
valve.
This
permits
water
to drain
from
the
dishwasher
tank, pump and drain line. Disconnect
both
the inlet
and outlet
lines at the FILL
valve. Make pro-
visions
to control
water
drained
from
unit.
Reinstall
lower panel. Turn on electrical
power.
On Custom
and Imperial
models,
close door and latch
handle.
Turn
Cycle
Selection
Dial
until
it clicks
in
"Rinse
& Hold"
position.
Push "Rinse
& Hold"
button
and allow
machine
to run until
it turns
off.
Turn
off
electricity.
On Patrician
and Superba models, close door and latch
handle.
Push "Rinse
& Hold"
button.
Allow
machine
to run four or five minutes.
Push "Cancel
Cycle"
button
and wait
for machine
to turn off. Turn off electricity.
To complete
installation
later:
Remove lower panel.
Connect
drain
and fill
valves (both
inlet
and outlet).
Reinstall
lower panel.
Turn on water and electrical
supplies.
KITCHENAID
DIVISION
TROV,
OHIO
45374
FORM
1366OA
(2-61)
(Sup&.
F. 136MI
PRINTED
IN U.SA.
4177829
Ivhpl.