HIKVISION TurboHD H0T Series Panduan Pengguna - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kamera Keamanan HIKVISION TurboHD H0T Series. HIKVISION TurboHD H0T Series 15 halaman. Turbo hd bullet & dome camera
Juga untuk HIKVISION TurboHD H0T Series: Panduan Pengguna (17 halaman), Panduan Pengguna (16 halaman), Panduan Pengguna (17 halaman), Panduan Pengguna (13 halaman), Panduan Pengguna (18 halaman), Panduan Pengguna (15 halaman), Panduan Pengguna (17 halaman)

2.3 Ceiling Mounting of Type III Camera

Before you start:

The ceiling mounting and the wall mounting are similar.

Following takes ceiling mounting as an example.

Steps:

1. Paste the drill template (supplied) to the place

where you want to install the camera.

2. Drill the screw holes and cable hole (optional) on

the ceiling according to the drill template.

Note:

Cable hole is required, when adopting the ceiling

outlet to route cables.

3. Loosen the set screws to remove the bubble.

Note:

You do not have to loosen those screws entirely.



Remove the bubble with care. The bubble is



connected to the mounting base with a safety

rope.

4. Route the cables through the cable hole, or the side

opening.

5. Attach the mounting base to the ceiling with

supplied screws.

Figure 2-9 Attach the Mounting Base

6. Connect the corresponding cables, such as power

cord, and video cable.

7. Power on the camera to check whether the image

on the monitor is gotten from the optimum angle. If

not, loosen the tilt adjusting screw to adjust the

angle.

Figure 2-7 Drill Template

Figure 2-8 Remove the Bubble