HIKVISION TurboHD H0T Series 사용자 설명서 - 페이지 8
{카테고리_이름} HIKVISION TurboHD H0T Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKVISION TurboHD H0T Series 15 페이지. Turbo hd bullet & dome camera
HIKVISION TurboHD H0T Series에 대해서도 마찬가지입니다: 사용자 설명서 (17 페이지), 사용자 설명서 (16 페이지), 사용자 설명서 (17 페이지), 사용자 설명서 (13 페이지), 사용자 설명서 (18 페이지), 사용자 설명서 (15 페이지), 사용자 설명서 (17 페이지)
페이지 인쇄
2.3 Ceiling Mounting of Type III Camera
Before you start:
The ceiling mounting and the wall mounting are similar.
Following takes ceiling mounting as an example.
Steps:
1. Paste the drill template (supplied) to the place
where you want to install the camera.
2. Drill the screw holes and cable hole (optional) on
the ceiling according to the drill template.
Note:
Cable hole is required, when adopting the ceiling
outlet to route cables.
3. Loosen the set screws to remove the bubble.
Note:
You do not have to loosen those screws entirely.
Remove the bubble with care. The bubble is
connected to the mounting base with a safety
rope.
4. Route the cables through the cable hole, or the side
opening.
5. Attach the mounting base to the ceiling with
supplied screws.
Figure 2-9 Attach the Mounting Base
6. Connect the corresponding cables, such as power
cord, and video cable.
7. Power on the camera to check whether the image
on the monitor is gotten from the optimum angle. If
not, loosen the tilt adjusting screw to adjust the
angle.
Figure 2-7 Drill Template
Figure 2-8 Remove the Bubble