HIKVISION TurboHD H0T Series 사용자 설명서 - 페이지 6
{카테고리_이름} HIKVISION TurboHD H0T Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKVISION TurboHD H0T Series 15 페이지. Turbo hd bullet & dome camera
HIKVISION TurboHD H0T Series에 대해서도 마찬가지입니다: 사용자 설명서 (17 페이지), 사용자 설명서 (16 페이지), 사용자 설명서 (17 페이지), 사용자 설명서 (13 페이지), 사용자 설명서 (18 페이지), 사용자 설명서 (15 페이지), 사용자 설명서 (17 페이지)
페이지 인쇄
2 Installation
Before you start:
Make sure that the device in the package is in good
condition and all the assembly parts are included.
Make sure that all the related equipment is power-off
during the installation.
Check the specification of the products for the
installation environment.
Check whether the power supply is matched with
your power output to avoid the damage.
Make sure the wall is strong enough to withstand
three times the weight of the camera and the mount.
If the wall is cement, insert expansion bolts before
installing the camera. If the wall is wooden, use
self-tapping screws to secure the camera.
If the product does not function properly, contact
your dealer or the nearest service center. Do NOT
disassemble the camera for repair or maintenance by
yourself.
2.1 Ceiling/Wall Mounting of Type I Camera
Before you start:
The ceiling mounting and the wall mounting are similar.
Following takes ceiling mounting as an example.
Steps:
1. Paste the drill template (supplied) to the place
where you want to install the camera.
2. Drill the screw holes, and the cable hole (optional)
on ceiling according to the drill template.
Note:
Drill the cable hole, when adopting the ceiling outlet
to route the cable.
3. Route cables through the cable hole or the side
opening.
4. Attach the bracket to the ceiling and secure the
camera with supplied screws. For cement ceiling,
you need to mount expansion bolts at first.
Figure 2-2 Attach the Camera to the Ceiling
Note:
The supplied screw package contains self-tapping
screws, and expansion bolts.
5. Connect the corresponding power cord, and video
cable.
6. Power on the camera to check whether the image
on the monitor is gotten from the optimum angle. If
Figure 2-1 Drill Template