IKEA DISHWASHER Petunjuk Pengguna - Halaman 5

Jelajahi secara online atau unduh pdf Petunjuk Pengguna untuk Mesin pencuci piring IKEA DISHWASHER. IKEA DISHWASHER 24 halaman.

Halaman Cetak

Add Rinse Aid

■

Your dishwasher is designed to use rinse aid for good drying

performance. Without rinse aid your dishes and dishwasher

interior will have excessive moisture. The heat dry option will

not perform as well without rinse aid.

■

Rinse aid keeps water from forming droplets that can

dry as spots or streaks. They also improve drying by

allowing water to drain off of the dishes after the final

rinse.

■

Rinse aid helps to reduce excess moisture on the dish

racks and interior of your dishwasher.

■

Check the rinse aid indicator. Add rinse aid when indicator

drops to "Add" level.

■

To add rinse aid, turn the dispenser cap

to "Refill" and lift off. Pour rinse aid into

the opening until the indicator level is at

"Full." Replace the dispenser cap and

turn to "Lock." Make sure cap is fully

locked.

NOTE: For most water conditions, the

factory setting of 2 will give good

results. If you have hard water or notice

rings or spots, try a higher setting. Turn

the arrow adjuster inside the dispenser

by either using your fingers or inserting

a flat-blade screwdriver into the center

of the arrow and turning.

Select a Cycle (cycles vary by model)

See "Cycle and Option Descriptions" charts in the following

section.

Heavier cycles and options affect cycle length. Some cycles and

options will take up to 3¹⁄₂ hours to complete.

Refill

¹⁄₄

turn to lock

STEP 3

Select Options (options vary by model)

See "Cycle and Option Descriptions" charts in the following

section.

You can customize your cycles by pressing the options desired.

Full

Add

Lock

Start or Resume a Cycle

■

Run hot water at the sink nearest your dishwasher until the

water is hot. Turn off water.

■

Select cycle and options, or press START/RESUME

to repeat the same cycle and options as in the

previous cycle. Push door firmly closed within

3 seconds of pressing Start/Resume.

■

You can add an item anytime before the main wash starts.

Open the door slowly and add the item. Push door firmly

closed within 3 seconds of pressing Start/Resume.

STEP 4