GREEN TECHNOLOGY GTS 1300 Manual - Halaman 3

Jelajahi secara online atau unduh pdf Manual untuk Chipper GREEN TECHNOLOGY GTS 1300. GREEN TECHNOLOGY GTS 1300 11 halaman. Woodchipper

Halaman Cetak

GENERAL

1. Manufacturer

De Wild B.V.

De Meeten 54

NL – 4706 NH Roosendaal

Tel: 0031 165 532 992

Fax: 0031 165 554 945

2. Intended use

The GTS 1300 is designed solely for chipping

all kinds of newly cut tree branches of

diameter up to 8.5 cm.

3. Restrictions

You should not use the GTS1300 for shredding/chipping metal, stones,

plastics. If you are going to shred tree roots check that the diameter is

less than 8.5 cm and remove all earth, sand and stones.

B efore using the machine for the first time, check the maximum engine

speed by screwing in/out the screw which controls the position of the

throttle lever so that it is positioned as in the diagram. (fig. 3) After the

first hour's use (just the first time; also after maintenance check) make

sure that the bolts of the blades and counter blade are still firmly fixed

and that the gap between blades and counter blade is 0.5mm (half

a millimetre). Use a torque wrench to tighten the bolts; 70Nm for the

blades on the rotor and 40Nm for the counter blade. Adjust in the slots

if necessary and fix the bolts with Loctite 243. (fig. 2a, 2b)

4. Description of the Machine

The GTS 1300 is a machine for chipping newly cut wood. The rotor

has 2 blades each with a 30 cm width and is powered by a 13hp

Honda engine. Transmission is through two parallel drive belts. The

shredded wood or chips are discharged through the output tube by

the centrifugal force of the rotor. Because of the angle of the blades

and the positioning of the counter blade branches are pulled inside

the machine automatically and no feeder belt is required. (fig. 1)

8,5cm

Manual Chipper GTS 1300

Fig. 1

Output pipe

protection

rotor axe

rotor

fig. 2a

fig. 3

Manual Chipper GTS 1300

Input pipe

engine Honda GX390

handlebar

emengency stop

fig. 2b

set screw