GREEN TECHNOLOGY GTS 1300 Podręcznik - Strona 3
Przeglądaj online lub pobierz pdf Podręcznik dla Chipper GREEN TECHNOLOGY GTS 1300. GREEN TECHNOLOGY GTS 1300 11 stron. Woodchipper
Drukuj stronęGENERAL
1. Manufacturer
De Wild B.V.
De Meeten 54
NL – 4706 NH Roosendaal
Tel: 0031 165 532 992
Fax: 0031 165 554 945
2. Intended use
The GTS 1300 is designed solely for chipping
all kinds of newly cut tree branches of
diameter up to 8.5 cm.
3. Restrictions
You should not use the GTS1300 for shredding/chipping metal, stones,
plastics. If you are going to shred tree roots check that the diameter is
less than 8.5 cm and remove all earth, sand and stones.
B efore using the machine for the first time, check the maximum engine
speed by screwing in/out the screw which controls the position of the
throttle lever so that it is positioned as in the diagram. (fig. 3) After the
first hour's use (just the first time; also after maintenance check) make
sure that the bolts of the blades and counter blade are still firmly fixed
and that the gap between blades and counter blade is 0.5mm (half
a millimetre). Use a torque wrench to tighten the bolts; 70Nm for the
blades on the rotor and 40Nm for the counter blade. Adjust in the slots
if necessary and fix the bolts with Loctite 243. (fig. 2a, 2b)
4. Description of the Machine
The GTS 1300 is a machine for chipping newly cut wood. The rotor
has 2 blades each with a 30 cm width and is powered by a 13hp
Honda engine. Transmission is through two parallel drive belts. The
shredded wood or chips are discharged through the output tube by
the centrifugal force of the rotor. Because of the angle of the blades
and the positioning of the counter blade branches are pulled inside
the machine automatically and no feeder belt is required. (fig. 1)
4
8,5cm
Manual Chipper GTS 1300
Fig. 1
Output pipe
protection
rotor axe
rotor
fig. 2a
fig. 3
Manual Chipper GTS 1300
Input pipe
engine Honda GX390
handlebar
emengency stop
fig. 2b
set screw
5