Avantco KEGERATRS Panduan Pengguna - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Peralatan Dapur Avantco KEGERATRS. Avantco KEGERATRS 13 halaman. Beer keg dispenser

Tapping the Beer Keg - Installing Keg Tap

(Single-Valve Type Barrel)

Follow the steps below to tap the beer keg.

1. Make sure the black pull handle of the tap is in the closed (up) position before installing it on the

keg (Fig. 1). Insert the keg coupler into the locking neck of the beer keg and turn clockwise ¼ to

lock it into position (Fig. 2). This means that it is secured to the keg.

2. When connecting the beer line, it is very important that the black rubber washer be installed

inside the wing nut before connecting the beer line to the tap (See Illustration A). Remove the

black rubber protective cap located on top of tap and screw the Wing nut with the rubber washer.

Tighten it firmly by hand. (Fig.2)

3. Attach the CO2 line end of the tube to the hose connection on the tap. Next, secure the tube by

using the remaining self-locking plastic snap-on clamp to ensure that there are no leaks. Secure

the clamp tightly with pliers (Fig. 3).

4. Make sure the beer tower faucet is in the closed (handle pointing straight back) position before

connecting the tap to the keg. To secure the tank connection, pull the tapping handle out and

push down until it locks into position. Listen for the "click" of the pull handle when it shifts into

the final downward position (Fig. 4).This will open the beer and CO2 gas valves. The keg is now

tapped.

5. Carefully tilt the keg and rest the

edge on the keg floor support

on the bottom of the interior

cabinet. Slide the beer keg

slowly, ensuring that it is properly

located (Fig. 5) and carefully

close the door.

6. Your Beer Keg Dispenser comes

with a 2.5 lb. CO2 bottle, which

should be able to dispense four

15 gallon kegs of beer.

User Manual

- 9 -