Avantco KEGERATRS User Manual - Page 9
Browse online or download pdf User Manual for Kitchen Appliances Avantco KEGERATRS. Avantco KEGERATRS 13 pages. Beer keg dispenser
Print Page
Tapping the Beer Keg - Installing Keg Tap
(Single-Valve Type Barrel)
Follow the steps below to tap the beer keg.
1. Make sure the black pull handle of the tap is in the closed (up) position before installing it on the
keg (Fig. 1). Insert the keg coupler into the locking neck of the beer keg and turn clockwise ¼ to
lock it into position (Fig. 2). This means that it is secured to the keg.
2. When connecting the beer line, it is very important that the black rubber washer be installed
inside the wing nut before connecting the beer line to the tap (See Illustration A). Remove the
black rubber protective cap located on top of tap and screw the Wing nut with the rubber washer.
Tighten it firmly by hand. (Fig.2)
3. Attach the CO2 line end of the tube to the hose connection on the tap. Next, secure the tube by
using the remaining self-locking plastic snap-on clamp to ensure that there are no leaks. Secure
the clamp tightly with pliers (Fig. 3).
4. Make sure the beer tower faucet is in the closed (handle pointing straight back) position before
connecting the tap to the keg. To secure the tank connection, pull the tapping handle out and
push down until it locks into position. Listen for the "click" of the pull handle when it shifts into
the final downward position (Fig. 4).This will open the beer and CO2 gas valves. The keg is now
tapped.
5. Carefully tilt the keg and rest the
edge on the keg floor support
on the bottom of the interior
cabinet. Slide the beer keg
slowly, ensuring that it is properly
located (Fig. 5) and carefully
close the door.
6. Your Beer Keg Dispenser comes
with a 2.5 lb. CO2 bottle, which
should be able to dispense four
15 gallon kegs of beer.
User Manual
- 9 -