Avantco UDD1 Panduan Pengguna - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Peralatan Dapur Avantco UDD1. Avantco UDD1 17 halaman.
Electrical Instruction
When using electrical appliances basic safety precautions should be followed:
- This cooler must be properly installed and located in accordance with the installation
service representative .
- Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this
or any other appliance .
- Unplug the unit from the electrical outlet before cleaning or making repairs .
- Setting the temperature controls to the (0) zero position does not remove all power .
Please ensure that the required voltage for the compressor is being supplied at all times .
If the voltage is unstable, please select a suitable automatic voltage regulator .
!
CAUTION: Low or high voltage can damage the refrigeration unit.
- All units should be plugged into a grounded and properly-sized electrical outlet with appropriate
overcurrent protection . Please refer to the electrical requirement on the nameplate . The power
cord of this cooler is equipped with a grounding plug which fits a standard grounding wall outlet
to minimize the possibility of electrical shock hazard .
Standard Plug: NEMA 5-15P
If the outlet is a standard 2-prong outlet, it must be replaced with the properly
grounded wall outlet. NEVER USE AN ADAPTER PLUG!
- Have the wall outlet and circuit checked by a qualified electrician to make sure the
outlet is properly grounded . Check the incoming voltage with a voltmeter .
- DO NOT USE EXTENSION CORDS. The use of extension cords to connect the cooler will void
warranty . The unit must be close enough to the electrical outlet so that extension cords are
never used .
- The cooler should always be plugged into its own dedicated circuit with a voltage rating that
matches the rating plate . This provides the best performance and also prevents overloading
wiring circuits which could become a fire hazard from overheated wires .
- Never unplug your cooler by pulling on the power cord . Always grip the plug firmly and pull
straight out from the outlet .
- Immediately repair or replace all power cords that have become frayed or otherwise damaged .
Do not use a power cord that has cracks or abrasion damage along its length or at either of
its ends .
- When moving the cooler away from the wall be careful not to run over or damage the power cord .
It is strongly recommended that any servicing be performed by an
authorized service representative.
User Manual
- 5 -