Avantco UDD1 Podręcznik użytkownika - Strona 5

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Urządzenia kuchenne Avantco UDD1. Avantco UDD1 17 stron.

Electrical Instruction

When using electrical appliances basic safety precautions should be followed:

- This cooler must be properly installed and located in accordance with the installation

service representative .

- Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this

or any other appliance .

- Unplug the unit from the electrical outlet before cleaning or making repairs .

- Setting the temperature controls to the (0) zero position does not remove all power .

Please ensure that the required voltage for the compressor is being supplied at all times .

If the voltage is unstable, please select a suitable automatic voltage regulator .

CAUTION: Low or high voltage can damage the refrigeration unit.

- All units should be plugged into a grounded and properly-sized electrical outlet with appropriate

overcurrent protection . Please refer to the electrical requirement on the nameplate . The power

cord of this cooler is equipped with a grounding plug which fits a standard grounding wall outlet

to minimize the possibility of electrical shock hazard .

Standard Plug: NEMA 5-15P

If the outlet is a standard 2-prong outlet, it must be replaced with the properly

grounded wall outlet. NEVER USE AN ADAPTER PLUG!

- Have the wall outlet and circuit checked by a qualified electrician to make sure the

outlet is properly grounded . Check the incoming voltage with a voltmeter .

- DO NOT USE EXTENSION CORDS. The use of extension cords to connect the cooler will void

warranty . The unit must be close enough to the electrical outlet so that extension cords are

never used .

- The cooler should always be plugged into its own dedicated circuit with a voltage rating that

matches the rating plate . This provides the best performance and also prevents overloading

wiring circuits which could become a fire hazard from overheated wires .

- Never unplug your cooler by pulling on the power cord . Always grip the plug firmly and pull

straight out from the outlet .

- Immediately repair or replace all power cords that have become frayed or otherwise damaged .

Do not use a power cord that has cracks or abrasion damage along its length or at either of

its ends .

- When moving the cooler away from the wall be careful not to run over or damage the power cord .

It is strongly recommended that any servicing be performed by an

authorized service representative.

User Manual

- 5 -