Makita 1923H Buku Petunjuk - Halaman 9

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Alat Listrik Makita 1923H. Makita 1923H 17 halaman. Power planer
Juga untuk Makita 1923H: Buku Petunjuk (13 halaman), Buku Petunjuk (18 halaman)

Halaman Cetak

1. European type (round) chip cover

2. Screwdriver

1. Vacuum cleaner

1. Screw

2. Nozzle assembly

OPERATION

1. Start

2. End

Connecting a vacuum cleaner

004902

For European countries and areas

When you wish to perform clean planing operation, connect a Makita vacuum

cleaner to your tool. Install the nozzle on the tool using the screws. Then con-

nect a hose of the vacuum cleaner to the nozzle as shown in the figures.

004951

For other countries and areas

A nozzle and joint (optional accessories) are necessary to connect a Makita

vacuum cleaner to your tool. Consult a Makita catalogue or representative on

the nozzle and joint.

Nozzle assembly (optional accessory)

004895

Use of the special nozzle assembly will minimize chip scatter, making for a

cleaner work area.

The nozzle assembly may be attached after the chip cover on the tool body is

removed. When slipping on the assembly, fit the pin on it into the rear cover

hole. Use the chip cover screws to fasten it in place.

Planing operation

004897

First, rest the tool front base flat upon the workpiece surface without the

blades making any contact. Switch on and wait until the blades attain full

speed. Then move the tool gently forward. Apply pressure on the front of tool

at the start of planing, and at the back at the end of planing. Planing will be

easier if you incline the workpiece in stationary fashion, so that you can plane

somewhat downhill.

The speed and depth of cut determine the kind of finish. The power planer

keeps cutting at a speed that will not result in jamming by chips. For rough cut-

ting, the depth of cut can be increased, while for a good finish you should

reduce the depth of cut and advance the tool more slowly.