Makita 3901 Buku Petunjuk - Halaman 5

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Alat Listrik Makita 3901. Makita 3901 16 halaman. 12-1/4" planer, blade sharpener, plate joiner, chain mortiser, blower, heat gun
Juga untuk Makita 3901: Brosur (1 halaman), Buku Petunjuk (12 halaman), Buku Petunjuk (17 halaman)

Halaman Cetak
Makita 3901 Buku Petunjuk
Dust bag
To attach the dust bag, fit
it
onto the dust
nozzle. If the dust bag becomes an obstacle
to your work, turn the dust nozzle to change
the dust bag position.
When the dust bag is about half full, switch
off and unplug the tool. Remove the dust bag
from the tool and pull the bag's fastener out.
Empty the dust bag by tapping it lightly to
remove as much of the dust as possible.
Size on stopper
0
10
20
S
h
Dust bag
D
MAX
Fastener
Dust nozzle
NOTE:
If you connect a Makita vacuum cleaner t o your plate joiner, more efficient and cleaner
~
-
Biscuit size
0
10
20
operations can be performed.
Adjusting the depth of cut
6 cutting depths can be preset according t o
the size of biscuit to be used or if trimming
the wall or ceiling panels as explained later.
Rotate the stopper until the pointer points to
the appropriate size marked on the stopper.
Refer to the table below for the correspon-
dence between the sizes marked on the
stopper and the biscuit size. Fine adjust-
ments t o the cutting depth can be made by
turning the adjusting screw after loosening
the hex nut. This may become necessary
after the blade has been reshamened a few
-
times.
8
mm
(5/16")
Depth
of
cut
10"
12.3"
13"
14.7"
2 0 m m
(0.4")
(0.48")
(0.51")
10.58")
(0.8")
Angle guide
The angle guide can be moved up and down t o adjust the position
of
the blade in relation
to
the top of the workpiece. To adjust the angle guide height, loosen the
lock
lever and
rotate the knob until the pointer points t o the desired scale graduation marked on the
angle guide. Then tighten the lock lever t o secure the angle guide. The scale on the angle
guide indicates the distance from the top of the workpiece t o the center of the blade
thickness.
Knob
\
Down
Center of blade thickness
5