Garage Tek GT4011EE Panduan Petunjuk Instalasi - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Kerekan Rantai Garage Tek GT4011EE. Garage Tek GT4011EE 8 halaman. Two point hoist

Halaman Cetak

SPECIFICATIONS & OPERATION

MAXIMUM LIFTING LOAD

MINIMUM LIFTING LOAD

MAXIMUM VERTICAL LIFT

MECHANICAL ADVANTAGE 3:1

THE UNIQUENESS OF THIS HOIST SYSTEM IS THE SELF-LOCKING SAFETY CLEAT. IT HAS A SPRING LOADED ARM

WHICH HOLDS THE CORD IN PLACE WHEN UNATTENDED.

WHEN RAISING AN ITEM, THE CORD SLIDES PAST THE ARM. WHEN THE CORD IS RELEASED, THE SPRING LOADED

ARM'S TEETH PRESSES AGAINST THE CORD, HOLDING THE CORD IN PLACE.

TO LOWER AN ITEM, 1) YOU MUST STAND AWAY AND THIS "OPENS" THE SAFETY ARM AND 2) THEN WHEN THE ARM IS

OPEN, YOU SLOWLY RELEASE THE CORD, ALLOWING IT TO "SLIDE" PAST THE ARM'S TEETH. THIS IS WHY A 15 LB.

MINIMUM LOAD IS REQUIRED. ie. LESS THAN 15 LBS OF TENSION WILL NOT OPEN THE SPRING LOADED CLEAT.

THE LENGTH OF THE HOISTING (PULL) CORD IS 35 FT AND THE STRAP ASSEMBLY IS APPROXIMATELY 2 FT. THE

MAXIMUM VERTICAL LIFT DISTANCE IS DEFINED AS 16 FT AND CAN BE USED IN A GARAGE WITH 18 FT HIGH CEILINGS.

----------------------------------------------------------------------------------------------------------------------------------------------------------

RECOMMENDED INSTALLATION W/ CEILING POWERTRAK & RING HOOKS

STEP 1A

STEP #1A: CHECK PARTS RECEIVED. WHEN INSTALLING THE HOIST USING A CEILING POWERTRAK

CHANNEL THE ABOVE PARTS W/O THE

STEP #1B: REQUIRED IS THE ADDITIONAL PURCHASE OF 2 RING HANGER HOOKS (GT9002E) AND THE

CEILING POWER TRAK (GT9150-10E). BOTH ITEMS CAN BE FOUND IN THE CEILING SYSTEMS CATEGORY

OF THE ESTORE.

PG 2

TWO POINT HOIST - ASSEMBLY INSTRUCTIONS

60 LBS

15 LBS (SEE FURTHER INFO BELOW)

16 FT

(SEE FURTHER INFO BELOW)

ARE USED.

QUESTIONS ???? CALL 1-866 664 2724

STEP 1B

REV 1, 01/12