Garage Tek GT4011EE Руководство по установке - Страница 2
Просмотреть онлайн или скачать pdf Руководство по установке для Цепные подъемники Garage Tek GT4011EE. Garage Tek GT4011EE 8 страниц. Two point hoist
Печатать страницуSPECIFICATIONS & OPERATION
MAXIMUM LIFTING LOAD
MINIMUM LIFTING LOAD
MAXIMUM VERTICAL LIFT
MECHANICAL ADVANTAGE 3:1
THE UNIQUENESS OF THIS HOIST SYSTEM IS THE SELF-LOCKING SAFETY CLEAT. IT HAS A SPRING LOADED ARM
WHICH HOLDS THE CORD IN PLACE WHEN UNATTENDED.
WHEN RAISING AN ITEM, THE CORD SLIDES PAST THE ARM. WHEN THE CORD IS RELEASED, THE SPRING LOADED
ARM'S TEETH PRESSES AGAINST THE CORD, HOLDING THE CORD IN PLACE.
TO LOWER AN ITEM, 1) YOU MUST STAND AWAY AND THIS "OPENS" THE SAFETY ARM AND 2) THEN WHEN THE ARM IS
OPEN, YOU SLOWLY RELEASE THE CORD, ALLOWING IT TO "SLIDE" PAST THE ARM'S TEETH. THIS IS WHY A 15 LB.
MINIMUM LOAD IS REQUIRED. ie. LESS THAN 15 LBS OF TENSION WILL NOT OPEN THE SPRING LOADED CLEAT.
THE LENGTH OF THE HOISTING (PULL) CORD IS 35 FT AND THE STRAP ASSEMBLY IS APPROXIMATELY 2 FT. THE
MAXIMUM VERTICAL LIFT DISTANCE IS DEFINED AS 16 FT AND CAN BE USED IN A GARAGE WITH 18 FT HIGH CEILINGS.
----------------------------------------------------------------------------------------------------------------------------------------------------------
RECOMMENDED INSTALLATION W/ CEILING POWERTRAK & RING HOOKS
STEP 1A
STEP #1A: CHECK PARTS RECEIVED. WHEN INSTALLING THE HOIST USING A CEILING POWERTRAK
CHANNEL THE ABOVE PARTS W/O THE
STEP #1B: REQUIRED IS THE ADDITIONAL PURCHASE OF 2 RING HANGER HOOKS (GT9002E) AND THE
CEILING POWER TRAK (GT9150-10E). BOTH ITEMS CAN BE FOUND IN THE CEILING SYSTEMS CATEGORY
OF THE ESTORE.
PG 2
TWO POINT HOIST - ASSEMBLY INSTRUCTIONS
60 LBS
15 LBS (SEE FURTHER INFO BELOW)
16 FT
(SEE FURTHER INFO BELOW)
X
ARE USED.
QUESTIONS ???? CALL 1-866 664 2724
STEP 1B
REV 1, 01/12