ALIBI ALI-NS4028R Panduan Instalasi Cepat - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Instalasi Cepat untuk Kamera Keamanan ALIBI ALI-NS4028R. ALIBI ALI-NS4028R 6 halaman. Ip bullet cameras
Juga untuk ALIBI ALI-NS4028R: Panduan Instalasi Cepat (5 halaman)
Halaman Cetak
1.
Scan through the list of devices the Alibi Config Tool discovered for the Inactive device you want
to activate (see below). Click on the device in the list to highlight it, and then click the select box
to check it. See below.
Activate
Click the Activate button. In the Activate window, you will create a password for the admin
2.
(administrator) username.
a.
In the Activate window, enter an a password for admin in the New Password field.
Include a combination of uppercase, lowercase alphabetic characters and numbers to
create a "Strong" password. The rating is shown beneath the field. See above.
Enter the admin password again in the Confirm field, and then click Activate. In the
b.
screen below, notice that the device Security status shows "Active". Record your admin
password for reference later.
If you lose your admin (administrator) password, you cannot configure the device or restore
it to its factory settings. To reset your password, call your support organization for specific
CAUTION
instructions.
Notice that although the device is now activated, it retained the default IP address.
Step 5.
Modify Network Parameters
NOTE: If the camera LAN extension cable is attached to a Network Video Recorder (NVR), skip this
step. The camera will receive network configuration settings from the NVR. Refer to the documentation
available for your NVR firmware for more information.
You can change the network parameters of devices that are active.
1.
In the list of devices discovered, click on the device you want to change the network settings for,
and then click the select box to check it. See below.
3
www.observint.com
Modify Network Parameters
2.
In the popup window, edit the current network parameters, and then enter the admin user
password in the field at the bottom.
a.
Enable DHCP: You can select Enable DHCP to acquire compatible network settings
from a DHCP server installed on the LAN. However, these settings can be changed by the
DHCP server. Since it is recommended to use an unchanging IP address, you can use DHCP
to acquire compatible network settings, and then uncheck Enable DHCP and save that
configuration to retain the new network parameters.
b.
In the example below, the IPv4 address was changed to 192.168.3.100, and the IPv4
Gateway was changed to 192.168.3.1. These settings were determined to be compatible
with the network router and other devices that share the same router.
Click OK to save your settings. The parameter change(s) will be shown device's network
3.
parameters (see below).
Step 6.
Login to the camera
NOTE: If the camera LAN extension cable is attached to a Network Video Recorder (NVR), skip this step.
Microsoft® IE is used to access your camera remotely. IE must run as an Administrator to use all features
available through a remote login to the camera.
Setting MS Internet Explorer to run as an Administrator
Window 7: To run IE as an Administrator:
1.
Find or create an IE icon on your computer desktop.
2.
Hold down the shift key, and then right-click on the IE icon.
MS Internet
Explorer icon
Click Run as administrator in the pop-up menu.
3.
Window 10: To run IE as an Administrator:
Find MS IE in the start menu. Usually this is found in the Windows Accessories group.
1.
Pin the entry to Start.
2.
© 2017, 2018 Observint Technologies. All rights reserved.
Run as administrator